Rear end gasket

Discussion in 'PSI Superchargers Tech Questions' started by dirty rat, Apr 26, 2005.

  1. dirty rat

    dirty rat Jr. Dragster

    Joined:
    May 8, 2003
    Messages:
    58
    Likes Received:
    0
    I have tried everymethod know to man to keep the gasket from leaking. The gasket pushs out from the housing. Tried paper, rubber, RTV, yellow death, no gasket, What do you recommend? Thanks STAN
     
    #1
    dirty rat, Apr 26, 2005
  2. kosky racing

    kosky racing Comp Eliminator

    Joined:
    May 11, 2003
    Messages:
    890
    Likes Received:
    48
    Is the rear vented?
     
    #2
    kosky racing, Apr 26, 2005
  3. Bob Meyer

    Bob Meyer Comp Eliminator

    Joined:
    May 13, 2003
    Messages:
    764
    Likes Received:
    36
    If it's a Ford 9-9.5" use a FelPro 2302 steel shim with HYLOMAR (absolutely NO silicone) on the housing side, white grease on the dropout face.
    Just like tightening your wheels, check and tighten at least the bottom four constantly.
     
    #3
    Bob Meyer, Apr 26, 2005
  4. Nathan Sitko - 625 TAD/TAFC

    Nathan Sitko - 625 TAD/TAFC TAD / TAFC

    Joined:
    Jun 24, 2003
    Messages:
    725
    Likes Received:
    1
    The fel-pro gasket that Bob mentioned works great! We always used to have a leak that was unstoppable in the rear end until we put this gasket on.
     
    #4
    Nathan Sitko - 625 TAD/TAFC, Apr 26, 2005

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM