Older strange floaters

Discussion in 'Manton Push Rods Top Alcohol Tech Questions' started by Dal Sangha, Mar 2, 2018.

  1. Dal Sangha

    Dal Sangha New Member

    Joined:
    May 12, 2016
    Messages:
    27
    Likes Received:
    1
    I have an older style strange full floater rear end. What Is torque rating for nut holding the hub. Thank you Dal
     
    #1
    James2 likes this.
  2. OwnBlock

    OwnBlock Member

    Joined:
    Jun 12, 2006
    Messages:
    219
    Likes Received:
    2
    up to 100 ft lbs. they sell the tool for this.

    personally i do mine up with 2 philips head screw drivers that fit nice into 2 of ring nut holes and a tyre lever, tighten to firm, install the 2 locking grub screws. never an issue. recommended is to check them periodically until you are satisfied, you should check the bearings any way.
     
    #2
  3. Dal Sangha

    Dal Sangha New Member

    Joined:
    May 12, 2016
    Messages:
    27
    Likes Received:
    1
     
    #3
  4. Dal Sangha

    Dal Sangha New Member

    Joined:
    May 12, 2016
    Messages:
    27
    Likes Received:
    1
    Thank you. Any idea on what the replacement seal would be on the back of the hub. The CR26328 is discontinuined. Local parts guys can’t cross it over. Thank you Dal
     
    #4
  5. turbo69camaro

    turbo69camaro Member

    Joined:
    Nov 26, 2007
    Messages:
    228
    Likes Received:
    6
    i snug it down not real tight then back off until the first keyway tab lines up and bend toothed washer to fit last time i got seals O Riley's had them
     
    #5
  6. tc1216

    tc1216 Member

    Joined:
    Dec 13, 2005
    Messages:
    91
    Likes Received:
    1
    Amazon, Just type in p/n, 2 choices come up
     
    #6

Share This Page