Clutch Sensor wire

On the clutch can (Titanium) is it permissable to cut a small notch to slip a wire between the can and removable access cover? Any tech issues? Have seen it done but keep reading the warning on the can. (Trying to get our computer running for the next event.) Thanks.....Brownman and the FNG's

 

not sure but i called regis at apollo trick titanuim to get the ok to drill a hole for the imput shaft sensor
if i remeber right it has to be on the flat side where the trans bolts up to it it can not be on the curved part
better call them to be sure

 

Discovered that if you bolt the can up to a Lenco trans, there is enough room to run the wire thru the pre existing bolt hole closest to the outside of the can. There are two factory holes for trans mounting in each position that a bolt goes. Thanks for the help. Brownman and the FNG's

 

hey John348......Right you are! regis called back today to say that they will permit a hole on the Flat Surface of the TITANIUM Can. Thanks Again Brownman and the FNG's