Cleaning out garage, Lencodrive can, carbon driveshaft Solid wheel centers, MW hubs, + lots more

Discussion in 'Noonan Classifieds' started by Soldierboy0098, Jan 12, 2018.

  1. Soldierboy0098

    Soldierboy0098 Active Member

    Joined:
    Feb 17, 2006
    Messages:
    1,157
    Likes Received:
    9
    New PST Carbon drive shaft w/ 1480 U-Joint and Strange short yoke 45 5/8 center to center +/- 1/8" Was for 2 spd Lenco drive in my 63 Vette Pro mod, I run a 3 spd so it will not work for me. Cost $1,700 new will sell for $1,300 + sh

    New in the box Browell steel can for Lenco drive/Hemi. Cost $1,400 new sell for $900. Was for a project that fell through.

    I have a pair of Weld Magnum pro solid (Top fuel) wheel centers that I do not need, 5 on 5.5, These are in great shape cost $1,060 new I'll sell for $500.

    11 or 12 Ross 4.375" Fathead pistons, 1.156 pin bore diam, 1.551 CH. Job #114537. Dome cc 21.52 using a 15.76-15.80 cc gasket and BAE 5 style 96cc chamber makes approx 12.68:1 cr. 1/16-1/16-3/16. Lightly used but in good shape $250 for all of them.

    Coated Dragster/Altered headers for BAE 4/5 fatheads $200+sh left over from my dragster. Coating off around the pipe staps in a couple of spots where some small repairs were made but not worn out and don't look bad.

    New ERD 1 1/4" stuffer plate for psi roots blower. Accomplishes inlet mod, very nice contouring, increases efficiency at mid range overdrives (30-50%). $100

    New PSI 1.5" stuffer plate for psi roots blower, increases blower efficiency at lower overdrives (25-45%) Paid $200 sell for $75
    or $125+sh for both

    Large tool tray w/ pneumatic setup leftover from my funny car, it's in the way so $100+sh (It's big and may need to go freight) Was very expensive new.

    I have some push/pull morse cables will try to get lengths

    A lot of old KB head studs, 1/2" diam I think, will verify when called. Call with a length if you need them. $200 for all of them.

    Calling, texting, or emailing is best as I may not catch the messages on ITA.
     
    #1
    Last edited: Jun 29, 2018
  2. anthony young

    anthony young New Member

    Joined:
    Dec 5, 2011
    Messages:
    17
    Likes Received:
    0
    Can you please send pics to aayoung392@yahoo for the tool tray thanks. Anthony
     
    #2
  3. Paul Vinyard

    Paul Vinyard New Member

    Joined:
    Aug 19, 2016
    Messages:
    16
    Likes Received:
    0
    #3
  4. Eastern Hustler

    Eastern Hustler New Member

    Joined:
    Nov 8, 2016
    Messages:
    16
    Likes Received:
    0
  5. Soldierboy0098

    Soldierboy0098 Active Member

    Joined:
    Feb 17, 2006
    Messages:
    1,157
    Likes Received:
    9

Share This Page