Cam sync signal for efi

Discussion in 'Manton Push Rods Top Alcohol Tech Questions' started by Rcjustin, May 12, 2018.

  1. Rcjustin

    Rcjustin New Member

    Joined:
    Jul 16, 2014
    Messages:
    12
    Likes Received:
    0
    I am going to be running fueltech with their spark pro 8 coil near plug setup on my BAE Hemi twin turbo combo. I will be selling my mag and drive setup. I’m running a system one hex driven oil pump so I still need something to drive that as well as a way to give a can sync signal to the ecu. Any ideas how to do this?

    An msd distributor with a Hall or magnetic pickup in it would work I’m thinking and just take off the distributor cap... just wondering if anyone has done this or had any other ideas.

    Thanks
    Justin Lehr
     
    #1
  2. shawn

    shawn New Member

    Joined:
    Oct 20, 2007
    Messages:
    11
    Likes Received:
    0
    RCD makes a pump drive/mag replacement with a cam sensor in the top of it.
    shawn
     
    #2
  3. Rcjustin

    Rcjustin New Member

    Joined:
    Jul 16, 2014
    Messages:
    12
    Likes Received:
    0

    Thank you. I’ll give them a call. Didn’t see it on their website
     
    #3
  4. Jason Green

    Jason Green Member

    Joined:
    Feb 20, 2016
    Messages:
    68
    Likes Received:
    4
    I think Snyder Motorsports has a setup that attaches to the mag drive
     
    #4
  5. kosky racing

    kosky racing Comp Eliminator

    Joined:
    May 11, 2003
    Messages:
    612
    Likes Received:
    21
    Electramotion makes the one for mag drive -go to their site there is shot of one
     
    #5
  6. Dal Sangha

    Dal Sangha New Member

    Joined:
    May 12, 2016
    Messages:
    29
    Likes Received:
    1
    Msd cam sync using the fuel pump Drive shaft. I have the magnet in the shaft and the sensor in the extension housing. Works great with Haltech elite.
     
    #6

Share This Page