8 Magnet Split Collar

Discussion in 'Manton Push Rods Top Alcohol Tech Questions' started by KENNETH JORDAN, Oct 26, 2018.

  1. KENNETH JORDAN

    KENNETH JORDAN New Member

    Joined:
    Nov 28, 2017
    Messages:
    3
    Likes Received:
    0
    Fellas,

    I have a aftermarket powerglide with a roller tail housing.
    Also have a hardened Moser yoke for application. I'm needing an 8 magnet split collar for my ARC module to read. The diameter of the yoke is 1.496". The smallest collar from Racepak is 1.812 diameter. Surely someone has found this before. Any ideas? Thanks ahead of time.

    kenken
     
    #1
  2. Mike Canter

    Mike Canter Top Dragster

    Joined:
    Mar 10, 2004
    Messages:
    4,162
    Likes Received:
    76
    Call Shannon Davis who make the Profiler Traction Control and see what he has (828) 335-5193
     
    #2
  3. drew556

    drew556 Member

    Joined:
    Jan 21, 2016
    Messages:
    43
    Likes Received:
    0
    Your driveshaft sensor should be on the rearend third member yoke not the driveshaft yoke
     
    #3
  4. Mike Canter

    Mike Canter Top Dragster

    Joined:
    Mar 10, 2004
    Messages:
    4,162
    Likes Received:
    76
    Not for traction control. It is better to have it at the other end. Sometimes you need two sensors one for traction control and one for the data recorder.
     
    #4
  5. sammy christian

    Joined:
    May 29, 2013
    Messages:
    54
    Likes Received:
    1
    the correct pickup and collar, that Davis has, has outputs for racepak and traction control in one.
    belongs on pinion yoke, trans yoke moves and would likely disrupt a proper signal.
     
    #5
  6. drew556

    drew556 Member

    Joined:
    Jan 21, 2016
    Messages:
    43
    Likes Received:
    0
    Ok Mike humor me why is it better to have it on the ds yoke
    Does carbon drive shaft twist ?
     
    #6
  7. Mike Canter

    Mike Canter Top Dragster

    Joined:
    Mar 10, 2004
    Messages:
    4,162
    Likes Received:
    76
    Someall driveshafts twist. Just found the signal more stable at the other end. Also in the past have found it better with the ARC to run two separate sensors rather than the combined unit but not so with the Profiler.
     
    #7
  8. KENNETH JORDAN

    KENNETH JORDAN New Member

    Joined:
    Nov 28, 2017
    Messages:
    3
    Likes Received:
    0
    this is for an ARC application. I'm going to mount on trans yoke. I have a machine shop going to make me a spacer that will have about .0005 press fit. Then put back in machine to finalize for split collar to fit perfectly. I have talked to Racepak and there are people that mount on trans yoke. I have researched as much as I can. This is one of those topics where you can ask 3 different people and get 4 different answers. So I will let you know how it turns out.

    kenken
     
    #8

Share This Page