Separate names with a comma.
I found that if you use a thermo gun directly on an aluminum head or block one gets a false low reading. If you paint a small flat black circle...
Connect the 8973 to your laptop open up the ProData software go to the Data Editor on the left side middle, expand it to full page then scroll...
You are probably right on as why you can use the start retard. Just remebr if one day it just will not start just disable the Start retard and it...
Then you are lucky. Maybe you use a crank trigger and because of where you have the rotor phased it still starts or you have an adjstable cap and...
Just don't use the 10* start retard because most mags don't produce enough spark while cranking to jump the increased rotor gap due to the retard...
I have a call into MSD and waiting for an answer to see if there is anything else that can be done.
Shannon, is the MSD 8973 physically grounded or is it sitting on rubber mounts? The same question for the Racepak? If the boxes are isolated you...
This might help you http://www.dragstuff.com/techarticles/reading-alcohol-spark-plugs.html
I agree, especially with that chilling breeze blowing on Sunday. Saturday was perfect.
You can use just the small MSD Two Step box. The difference with using a MSD Digital Box which there are many is that the Digital Box has a soft...
Good for Jay but not good for us as Steve Burck was in the left lane at the same time. Jay was gone in a flash. Looked like the jet car. It looked...
We use a Two Step with a Rootes blower on a ProMod car with no problems. It is very common in the Outlaw ProMod world. I can't see why you...
Well you posted it on the board then how about telling us all who you are after pulling the pin on the granade.
I believe they do. You also add more than normal crush from the aluminum bearing caps to hold the bearing in tighter.
Who exactly makes these L1000 springs. Do they have an info website?
We have switched to V bearings. One reason they stopped making M bearings for the FORD crank. The question I have is if you pinch a M rod upper...
Not for release yet. Maybe some time later as I am still trying to figure it out. Our Ford Hemi motor has a different torque curve as compared to...
I am listening and appreciate all the inputs. Now I have to add all that to what I have already have tried and figure out which is best for our...
Thanks for the tip but that is not what I am after. I am trying a different combination.
Can somebody email me what the most common rear gears are and what the 1st gear and 2nd gear used in a Lenco for FCs using Roots blowers. I am...
