Separate names with a comma.
1.5 to 2 inches. Putting it on the top will read a little higher than being on the bottom
I would stay with the gap range you had. Even with a ProMag 44 you still gap the plugs in the same range as what you are.
Call TJ or Rich at SSI and give them that serial number. They can tell you exactly what it is. 440.243.8668. I bet it is a Series B. What does the...
The air being forced into the hat at high speed will do that on any supercharger.
The higher you spin a rootes blower the more it heats the incoming air charge and the more power is lost. You want a high helix retro blower. Do...
You need a 168 tooth flywheel to fit your car plus the can with the starter pocket. If this motor has a ProMag 44 then the starter will have to be...
I have been doing it for years. I don't bounce them off the floor but will it off the floor with a rope and then tap the crank with a small hammer...
How did you verify the plugs wires as to how good the insulation is. Normally what goes bad first on plug wires is the insulation breaks down and...
Andre, what overdrive are you planning to use or restricted to on your car. Are you required to run a Rootes blower or can you run a screw blower?
Dave you haven't made it very clear if the cavitation that you describe because the pump has a problem or being turned too fast or is it because...
Unless the pump is cavitating the chances of getting air out of the pump are slim to none. Just think if the pump generated air then your system...
Right off MSD Website for laptops that have NO serial plug and only use a USB. We found that most other USB to Serial Adapters just go to sleep if...
Just as a reminder when thinking about a minimum setup on the 8973. You ALWAYS need the blue wire that runs to the 8973 hooked to a 12 volt reset...
As the Density Altitude changes the amount of HP produced changes so do the clutch requirements to handle that change in horsepower in both the...
If anyone wants to talk to Mike Sullivan about his Applied Physics clutch software he will be at Houston this weekend at Erica Enders trailer or...
Unless the pump is cavitating there sould not be any air being generated in the fuel pump. The only downside to returning the pump sizer fuel back...
Rickey, email me at mike.c@mindspring.com about your MSD 8973 problems.
I try and heat the motor up to a thermo gun reading on the front of the head to about 130* because after I shut it off it tends to heat soak and...
I would think the gauge and the temp gun should read the same temp in the same area.
No, flat black or dark surface reads the correct temps. It is the aluminum surfaces or shiney surfaces that can read incorrectly.
