Separate names with a comma.
We used to get bent exhaust valves after a run when we had a nitrous motor. It was only the exhaust valves that were open after shutdown and cool...
It will work at WOT if the pop pressure is exceeded by the pump pressure which can happen if it is set to low. The trouble is this can happen...
What is the highest pump pressure you have seen with any of your tuneups. Ours pops at 230 psi. You do not what to go too low like 100 psi or 175...
Thanks Will. I have often wondered on the real difference.
Take aclose look at Spud's website especially on the left side under calculators and also Tech notes. Spud can probably help you a lot in...
Bob, not to drag this out too much because it could go on forever and I do appreciate the time taken in responding. As you said you are...
http://www.psisuperchargers.com/news.php
Bob I would like to add one more item. I don't believe that calculating the AFR ratio is accurate enough to tell if a racer/tuner is close enough...
Bob, I have to apologize because I don’t think I actually explained myself clearly. Let me add some more for discussion about what I mean that the...
Greq since the inside diameter of both the rubber and the stainless steel lines exceed the diameter of the jets being used at the end of each line...
Bob, it would seem to me that the motor under the supercharger is fairly dumb and does not know that it has a PSI Screw blower or a Rootes on top....
The direction of the mag can be changed by MSD if needed.
Never had a problem with WD-40, never had it go sticky or gummy. As far as rotting the rubber hoses never heard of that, remember we also run...
After a race weekend we first connect up the high pressure air and blow through everything until all the alcohol has been blown out. Then we spray...
The heat range of a plug is the ability to transfer heat from the porcelein to the metal outer body of the plug. You are not reading a fuel ring...
A few years ago NHRA was going to make a rule change for Fuel FCs that if you used a Chevy body you needed a Chevy motor and if you used a Ford...
That injector is designed by an aerodynamic engineer at the same place where I work. and is the same as the one that Eric Medlen was using. We...
Our oil pump on our Boss 429 Hemi comes off the front on the drivers side just like that but our mag is on the drivers side. It is interesting...
The MSD Digital 7 shielded crank trigger cable is about the same price.
Dan, I show both those plugs to be 5/8 hex, 3/4" reach and with gasket. I also show that they are both a projected tip. If that is correct then I...
