Separate names with a comma.
The specified max pressures of the sensors that you buy have to match the pressure sensors that Edelbrock uses because there is a difference in...
The 6061 plug only takes a 13/16 socket as does the B9ES, the R5671 uses a 5/8 socket but we are only talking sparkplug sockets here. The threaded...
Changing the heat range will change the reading of a fuel ring on the porcelein of a plug IF you use a fuel that leaves a deposit when it burns....
Rick, we do see fibers from belt wear in the blower stuck to the gel. I used to worry about it and now I don't. The fibers and dudt and bugs are...
If you are having good luck and running great and have a tuneup then my recommendations is not to change anything.
You are welcome Craig.
No, the outer metal jacket of the plug immediately transfers the heat to the head and that relationship doesn't change with the heat range of the...
That's what I use. The only drawback is the ground strap is a little longer than the 6061. It just depends how much you are pushing the car or how...
vwsamba, why did you remove the gasket ring from your plugs?
That's confusing because the heat range of a plug is the ability to disapate heat from the porcelein to the metal jacket of the plug only. Since...
BJ, it is 45* or less. I am not sure that the term reflected back from the front of the manifold is the correct descriptions. It blows forward and...
Try Barnett Performance on the bearings http://www.barnettperformance.com/
Not for alcohol. Temps vary from logger to logger or if the probe goes through the top or through the bottom of the tube. The ones on top read...
Yes, you want the tip of the probe to be centered in the tube.
BJ, thereare rules as to how back a blower can be set. The Kobelco K-11 Superman is a HH set back blower to try and distribute the air closer to...
We just had our rotating assemble balanced and found out that we needed 150 grams added onto the crank. Was I shocked especially and the cost of...
email me at mike.c@mindspring.com and I will try and scan what I have and send it to you.
Yes I do for GM BB from a GM book. What dimension are you looking for?
I need a good air activated 12 volt switch to tee into a Lenco pod so I can activate some stuff at the shift. Any recommendations as to which...
I agree with Les. The early PSI's had a few problems but they seem to be fixed now. My second choice would be a Littlefield with the K-11 rotors....
