Separate names with a comma.
Doug have you bought the 8973 yet? It comes with a wiring harness and my guess is that is the part number for the included harness. I have never...
If you want the readings to be accurate then you have to have the straight section before and after the flow sensor. You can shorten it up all you...
You also need at least 4-5" of straight line between the flow meter and the barrel valve and 4-5" straight line before the Y to stop turbulance in...
I wish you a lot of luck with that air throttle we could never make it work correctly and safely. From my experience I think they are dangerous....
I agree with Ken. .150" on the exhaust and .125" on the intakes. The exhaust is the one that always seems to be on a collision course with the...
Rob, you need to contact Mike or Pat Norcia at RAM Clutches. A question for you....have you owned this clutch from the start or did you buy it...
The B9ES is a 13/16 hex version of the 5/8 hex R5671A-10. The 6061-10 has a very short side groundstrap vice the longer over the top groundstrap....
It is said that if they are too long that they have a tendency to light up like a glow plug and cause detonation. This would only happen if you...
Joseph, if you go back one page (page 3), Bob Kraemer has a couple of links to download them. If that doesn't work then let me know.
Then try an Autolite AR3932. It has a shorter ground strap.
On the rods it is just not worth the risk. If they have 20 passes on them then make clocks out of them. Figure what the damage would be to the...
Or http://www.blowerdriveservice.com/8mm.pdf
Bob, go up the page 4 posts to Bob's post and he has the download site to get them.
Since the intake runner is under pressure with a blower motor you don't need seals to stop the oil being sucked in like on a unblown motor.
I would try .080 on the launch and see if that will settle things down then .060 on the high speed and start pulling fuel out to get heat in the...
Here is something you might want to try. Take one of the electric high speeds and hook it to a Digi-Set timer and activate the Digi-Set with a WOT...
On the blower rotors. Changing the twist from 60* to 120* changes the output flow characteristics of the blower and moves it forward therefore the...
These charts are for flowed Enderle jets. This means that if you have flowed jets then they are probably flowed to this standard. If you jets are...
