Separate names with a comma.
The amount of fuel pressure is controlled by the total area of all the hat and port nozzles jets and the area of all the bypass jets. The higher...
There is probably something common there between Al Billis and Oddy since Al used to drive for them.
I have also been told that there is a dealer in La Verne, CA Phone # 1-909-596-8810, Bill Mizia at B& T PERFORMACE ENGINE BALANCE
You need a piston with a bigger dome. Try JE Pistons or CP Pistons and see what they have.
Thats OK. I learned to type fast with two fingers. Or figures compute out the same
Thanks Bob
With a 7.140" rod that will put the piston at 0.027" down in the hole which is where you want it. Now go and re-compute the CR using the piston...
So do we think that was an Al Billes modified Rootes blower on that car?
A 6.971 rod with a 4.25 stroke (2.125 for computations) and a 1.28 compression height is a total length of 10.376". If you subtract that from...
Rod stretch from too many runs or during a miss shift or losing a sprag or anything like that. I got that measurement from several well known...
My recommendation is to get the serial numbers off both blowers and call Littlefield at 714-992-9292. The problem for the standard blowers is heat...
I guess I am a little confused. The compression height is what gives you how much the piston is down in the cylinder and not so much the...
Then my recommendation would be to run the compression ratio around 11.5 to 11.7.
What OD are you going to run? How much boost do you think you will make?
That is hard to say. Since you now have a baseline performance with it out then I would try it with it in and see what happens. It will probably...
According to Rich at SSI putting the spacer in will increase boost but will lessen CFM. This really helps if you are running low OD. As far as the...
Kendal oil used to be made by Kendal Tosco and was bought out by Union 76 then by Phillips and now because of mergers I believe is owned by Conoco...
We had the same thing happen because the pump saver was set at the wrong pressure. Theoretically if the barrel in the BV is wide open it can't...
I have run all synthetic in all my cars since 1979. Used Mobil 1 and have never had an egine failure or one that is worn out. We use 70 wt...
We use Amerilube synthetic oil and have never had problems. I believe Synergyn oil has been used by Jim Oddy and Warren Johnson in the past...
