Separate names with a comma.
With the High Speed in the port line the hat will still feel the pressure drop and the hat flow will still be reduced.
Ralph Gorr and I am sure there are others.
A lot depends on what you want to see or what you need to tune the car. If you don't use any tuning software then some of the uses of the fuel...
There is alway a pressure drop across the barrel valve. It varies depending on what kind of barrel valve.
The placement of the high speed bypass in the port nozzle line out of the barrel valve was for simplicity and it works. Yes the whole fuel system...
A good start out place would be off the lower leg of the barrel valve going to the port nozzles.
This is from a previous post on this board Torquing Sequence for Brooks rods After bolts are snugged, alternate from bolt to bolt in the...
Does it use a oring or a gasket between the blower and the manifold? I would check there first. Also did you have to install an adapter plate when...
Lars, the only place to get spares like that is from Lenco http://www.lencoracing.com/
We used SpeedPro Hellfire rings in nitrous and they are great. I know several blower cars that use Hellfire rings. My understanding is tthat they...
I use the Akerly and Childs Xtreme rings and have had no problems yet and I have been way off on the tuneup a couple of times
You can get it from Graingers or MSC Industrial Supply
What OD are you going to use?
We have never lost a Crane lifter. Our lifters also have a small laser cut high pressure oil hole which feeds oil directly down to the roller.
If half the cadium is still on the plugs then you are running way rich. Read this at...
Kevin, congrats to you and your Dad. That is a great accomplishment. Thanks for the data. I know you don't want to give anything away. I really...
When you say the tuneup is a little rich then do you really know how rich it is? Do you run a high speed bypass? What do a set of plugs look like...
Is it a Al Billis modified Kobelco
Yep, after seeing that picture that is Darren's two hole hat. Can't tell much about the blower but that would be a good assumption that it is the...
I believe the deck of the piston is the point from the wrist up the amount of Compression Height. With some dome pistons the deck is plainy...
