Separate names with a comma.
Joseph it is pretty easy to estimate HP via BSFC from naturially aspirated racing motors. The will always have a BFSC of in the low .4. ProStock...
Yes, you can attach a strain gauge to the driveshaft and measure horsepower. I have seen a company at PRI demo it.
I do believe the .3 GPM figure is a safe rule of the thumb. The boost to HP increase can actually be computed mathmatically if you know the...
You have to talk lbs of boost here and not percent of OD. Not all blowers put out the same amount of boost for the same amount of OD. There are...
Is that .3 GPM for a Rootes blower or for a screw blower? There is a difference. A Rootes blown motor is making about 400 HP more than what is at...
I think you are getting off on a tangent with the choke system on a carb car comparison. The problem with a cold motor at 20* is that the fuel...
Justin you ain't nerding it up. These kind of questions are in our heads all the time and we would love to have it proven one way or the other....
That would be interesting test on the staggered fingers on the clutch dyno. I say that according to the laws of physics that all the levers...
Forgot the link http://www.engineersedge.com/manufacturing_spec/torque_wrench_1.htm
Go up on this site and just under all them formulas it says "Open Calculator" click on that and it will compute it for you. So if you have a...
Sorry Charlie, I misunderstood what you were trying to say. It sounded like that you only put all the weight on every other finger or put a...
Good question. The aerated nozzles serve two purposes, they suck in air and mix with the fuel to help atomize the mixture when fuel pressures are...
Having weight on some levers and maybe none on others does not make the application of the pressure from the lever come on at a different rate. If...
The jets normaly start large in the front of the hat and progress downwards in size all the way to the back of the blower. The jets from one side...
Call Brian Scollon at GRP 303.935.7565 and discuss it with him. He is a good man to talk to.
Mack, I remember that discussion. On a HH the air going into the top of the blower goes to the back of the rotors at a step angle. The air coming...
That amount of mass spinning at that RPM you need to keep the weights within a cetain range of each other. What that range is I don't know. All my...
I would tend to believe that considering the amount of horsepower a pump needs to be run on a flow bench.
You need the biggest hat you can see over the top of. You do need to make sure that the hat matches the opening in the top of your blower.Try...
What overdrive are you running and how much boost do you make? How high in RPM are you going?
