Separate names with a comma.
Did this logger noise just suddenly start or has it been there all the time? Are you saying the noise started when you changed JUST the coil wire...
OK you are still not making much boost. The difference in the amount of boost can be contributed some to the change in barometric pressure from...
Jesel say they want 1/2 to 1 1/2 complete turns out. I find that if you want just a 1/2 then you have to be super accurate on pushrod length...
That's why I asked him to take the belt off a spin the blower by hand to see how much resistance there is. If it is tight then a leaky gasket is...
Different style jets with different flow coeficients. Just because two different style jets have the same size orifice doesn't mean they flow the...
They are my flow data sheets from data from Ralph Gorr corrected to alcohol.
It is common to flow pumps and fuel systems with water and then make the correction after. The correction is simple math. It is cheaper and safer...
I know which charts are being passed around and if that chart doesn't say it is flowed in ALCOHOL at the top then it was the one that was flowed...
Changing the OD will not help. It needs new stripes. Take the belt off and see how is it is to turn with your hand. There is probably little to...
I would like a copy too. mike.c@mindspring.com
I was under the impression it was the K-8's and the crack along the top half of the lobes where the strips/screws are and then come apart. The...
Yes, I lowered it a liitle for a 540 motor. Even if a little off we are talking at least 10 lbs low on boost if that 20 lbs was at 8000 rpm. This...
At 8000 RPM I think the boost of 20 lbs is low at 28% OD. Somebody jump in here but I think you should be around 30 to 32 lbs of boost. How old...
Is that max boost at what RPM or boost at 8000 RPM. Either way that is pretty low boost at 28% OD if that is max. It would suggest that it maybe...
You should use a -9 or a -10 plug. Probably the best would be a NGK R5671A-10. Remember alcohol does not foul a cold plug and you are not reading...
I just got off the phone from Ray Akerly (he knows of no Tom) at Akerly and Childs. That is Ray Akerly and Rocky Childs. Is this complicated, at...
That has been discussed more than once in this forum. I would suggest you take some time and look back over the last month or do a search on Two Step.
678.777.3672
That is correct. the hemi does not push oil up the pushrod like some other motors so it doesn't need adjusters with holes in them. Yes, you back...
I do not use TriArmor H bearings in any blown application on rods or mains. They are just not forgiving enough.
