Separate names with a comma.
The resistor plug will not help. Don't waste your time. I already looked into it.
So are you saying this doesn't happen on cooler, drier days? Do you read the weather to get the Density Altitude and adjust your tuneup for...
There is a lot of difference on the initial hit with a blower motor to a nitrous motor. If they are Hoosier tires I would try dropping the...
I use plastic black tubing for my boost gauge on two cars. I use the DOT air brake approved hose only. It is thicker and stronger. There is no...
Percentahe depends on if it is a screw or Rootes. Normaly try for 60-65% in the hat on a Rootes and a lot less on a screw.
It would be close to the same as yours maybe a little higher due to friction of the rotating rotors. We also use the alcohol to lubricate and seal...
Yes it is because of the alcohol.
For comparison a Screw blower is 115-119 and a rootes is 125-130. Those temps are dependent on the amount of OD also.
The whole terminology og High Speed Bypass is screwed up because you activate them at the start or first part of first gear. What is High Speed...
Sune, at what RPM do you see just under 25 lbs of boost?
Sorry Richard. Yep thats what you said.
Yea, but you can also use a pump loop as a High Speed to help in additional launch tuning.:D:D
I think you have it backwards. When the limited Promod to 20% OD then a lot of racers started eyeing the standard blower to get more boost but...
Even if you put a High Speed just in the port or hat line it will still take fuel out of the complete system because the whole system fuel...
Never known it to. Can you be more specific on your question as to what problem in a burnout?
You don't have to shut 12 volts off. That line to the 12 volts will only be 12 volts even with a 24 volt charger attached on on. We do it all the...
OK then go and try it but I think you will be disapointed because you will not make enough boost on a standard blower and with that low motor RPM...
Yes you can
So you are saying that you have the same amount of teeth on both pulleys??? Which is 0% OD. If that is so then you are going to be real disappointed.
Running a 24 v starter does not effect the 12 volt system we do it all the time on our PM. The 24v chargers at around $300 so maybe the DMPE...
