Separate names with a comma.
I agree with nuts. Pull the pan and check the bearings especially your thrust bearing. A little glitter is normal but hard to tell how much on the...
I agree with the 50" 7". That is a good starting point. The other problem might be your rear shocks. Either the valving is not heavy enough for a...
Good question and I don't know the answer on if a 15 opening is better. I know that the standard now appears to be 10.5 or smaller.
You are normally limited in pill size by the orifice in the solenoid. Most are around .110-.125 in diameter so normally you can use a 80-120 jet....
You only need to pull timing if you can't get off the line but in moderation. You can pull timing with a Six Shooter and some kind of timer or...
I think how much a spacer helps is dependent on how the hat matches the opening in the top of the blower, the design of the hat, and is dependent...
If you have an air controlled throttle combined with a Two Step you will not make the boost because the blades are NOT open. You have to have the...
OK you said you had 30 lbs of boost after the overdrive change but how much did you have before the change? A little earlier this season with...
Well the fuel increase of .3 gpm was only really good for one pound increase in boost pressure. I agree that I think he had more than one pound in...
So how much did you see your boost go up after you changed your overdrive from 25 to 30 percent? Do you have a fuel flow sensor or a data logger...
Maybe the reason it ran in the past is because it had a lean problem. Now you have fixed all that it is just now running too rich. I say lean it...
The tester is only to make the 8973 think that it has an RPM input. It would be no good on a Six Shooter that uses a timer.
Call Dave Leahy
I have never lost a rod due to specifically a bolt breaking. I don't believe I have ever known anyone that has lost a rod because a bolt broke. It...
I use the 8998 all the time on testing MSD 8973s with ProMags. It simulates a crank trigger input and makes the 8973 think it has the motor...
DC Winters, you are correct. I sorry for not giving enough detail. I was doing talking about it at an upper level. I run the Hobbs switch to a...
Good point Bob. I guess that is a hint on his gear ratios.
There are several ways which that could have been done very fast with a 8973. You could have used the MSD small handheld programmer plugged into...
You are asking for someone to give out their secrets. My suggestion is to call Crower and ask them for a baseline setup or pay a tuner.
It does show up in a test and it easily detectable as soon as you start the motor because of the smell.
