Separate names with a comma.
Is it a bearing or a bushing? What are the indications when it goes bad?
With that low peak RPM and that boost of only 8 lbs then yes you need the smaller pump. You may also want somebody to flow the system as it is now...
I don't think it is the clutch dust or we would all have that problem. The only time that shaft spins in that bearing is when the clutch pedal is...
Do you have any idea what your fuel pressure is at 8000 RPM? I would switch to a smaller pump since you are making such a small amout of boost....
Nope, nothing. If they are tight going into the manifold when using your fingers then the soft metal threads were probably banged.
I normally just tighten the studs about 120 inch lbs into the manifold and also tighten the nuts holding the blower down at 120 inch lbs. When you...
Is that a two piece wheel? Is the wheel bolted to the hub assembly? If so is that where the problem is? Was it bolted together crooked from the...
Sometimes when you can't idle down an injector hat it is because there is an air leak between the injector hat and the top of the blower. I always...
According to Darren at DMPE his hats have more power on the dyno without the dividers. I believe the older Enderle hats work better with dividers.
There is no nitro in M5. There is an oxidizer to release more O2 but no nitro. Works well buts smells weird. If you use it you need to enrichen...
Get Jetsize out and calibrate it for your motor. Add a 40 jet Pump Sizer Loop through a 30 lb poppet crack pressure and see what happens to your...
Mightymouse. You need to correct Jetsize to match your car. Davenport talks about this in his instructions but it is not very clear. Here are my...
The DOS and Windows version give you the same answer just in a different format.
I will not go into the 30's. Either way you need a fuel strainer screen on the inlet to the BV or an inline fuel filter. Remeber if you reduce the...
You block off the bottom leg of the K valve. You can still use a high speed on it but it will not flow to the port nozzles. Then you change the...
As much as you can through the blower without making the port jet size too small as to catch dirt. It is hard to get much above a 65%/35% split...
Yes it does.
I totally agree. Buy it you will not be sorry. It works really well if you have a fuel flow sensor then you can calibrate Jetsize to the car and...
I am not sure that a heat sink compound would allow proper seating of the bearing. I believe it would be too thick. Good idea.
Just wipe both surfaces clean to make sure there is no dirt. I always then apply just a wiping of oil with my finger.
