Separate names with a comma.
The other solution is the wing angle BUT if too much angle then the wing will stall and you will loose all lift and it will be like a boat anchor....
To add: The density numbers are actually worse than you think. At 9400 ft. and about 70 deg. F, air density is approximately 30% lower. Back...
OK, Graham, Joe Pando of MSD (Mr. Promag) says that the 7551 Launch Rev Limiter Controller will work on the 8973 and all MSD Digital Programable...
Graham, there is a small box MSD part # 7551 that is a Rev Limiter Switch Box that can be plugged into the 8973 via the RS-232 cable. According to...
What color are the washers under the head bolts? Silver or black?
Call Crane Cams. http://cranecams.com/ They are in business again
Remember if you haven't gotten the Davenport's update to your Jetsize software and your computer switches to Daylight Savings Time in the morning...
Dave, you absolutely correct. It was in the factory engine manual for my 351C in my brand new 1971 Mustang. When Dave says a thin smear between...
Everybody chime in here with their experience. I would say that those bearings got like that from an oiling problem and NOT detonation. The fact...
I think Tony Ramos is 100% correct in what he has stated on your fuel and timing setup. The big confusion factors that is leading you astray are...
We should also take note of "blackened bearing" That is usually caused by a no load high RPM situation according to Clevite. It might help if we...
That is a close as you can get with that size tire to be the same as a 34" tire with a 4.56.
If the rod clearances were too big or not enough oil pressure might show that. Fuel shooting out the pipes is only seen at idle right? What are...
Crane does not do it anymore because of the odds of being successful are slim. That axle that goes through the roller and the supports cannot be...
Remember it is not just boost that counts, it is also how little amount of HP it takes to drive a screw blower and the cooler air charge. 45 lbs...
The biggest reasons some of these Outlaw cars do not perform with screw blowers are that they don't understand the difference in efficiency...
Don, Will is 100% correct. I don't understand your statement about Outlaw cars not running that fast with screw blowers. Frankie Taylor ran a 3.59...
Don't mean to piss on your shoes BUT.......Stop and think here how much damage you did before with that Whipple because you didn't have the...
Trev, phone call on the way
I agree with Reehl, you can put plugs in the current holes and re-drill at a different angle. We do it all the time with multi-stage nitrous nozzles.
