Separate names with a comma.
MSD back room guys told me always to be in AUTO with a promag even with a crank trigger but I will double check my memory and ask them again and...
Used to compensate the Mag pickup trigger retard timing. User adjustable as 0.0, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, AUTO. Manual is active from 3,000...
Yes, it will sound different. The 8973 has a "Soft Touch" rev limiter that uses software to make sure that a cylinder(s) is not shut off for two...
Depends how much boost you want right at launch. A Two Step gives you a lot of boost off the line (25-27 lbs) because the butterflies are wide...
They other thing you can do is to email me your saved MSD file for the 8973 and I can look at it and see if anything is setup incorrectly. I doubt...
Yes, the heads should be grounded to each other and then to chassis ground and should be the same ground as the coil. Swap your use a ohm meter...
No there are no problems with the box except for possible Electromagnetic Interference (EMI) from the high energy spark being picked up by using...
BAE motors with BAE heads can have that problem. BAE changed the tightening sequence on the head studs which takes care of most of it. BAE...
I think because of the erratic sound out the exhaust that people think that it is generating some big stress on the moving parts which it is not....
Robert the spacer is to increase airflow into the blower by moving the injector hat forward and lessening the angle that the air has to turn going...
Shubox57, what is your definition of high. 8500, 9000, 9500, 10,000 or higher? What are you turning yours to now?
Right off the top of my head I would say NO. Remember that pump is sucking a whole bunch of fuel to be able to pressurize it to 150 psi.
Don't get me wrong, I would go for the PAC springs also but that is a expensive initial investment but they are great. A lot would depend on what...
Just talked to Wizards Warehouse on the NGK R6061-10 plug cost is $4.75 each. Great price http://www.wizardswarehouse.com/contactwizards.htm As...
Call John (Wappado) Scialpi, his shop is 760.868.4878 and his cell is 626.695.2596. He makes them with two or three solenoids on a manifold. Does...
Stop and think guys. The thickness of the headgasket and the pushrod design tip or pushrod length has nothing to do with the lift of the valve IF...
It would make a difference being at 20% now and going above 30% later. Are you staying at 20%? If you are staying at 20-30% then the CRANE...
What overdrive are you using on the Roots?
No special orientation required. I have seen both at all positions. There is nothing mechanical inside the points box.
You are talking about the connection box for all the EGTs is that correct? If so I would not mount that on the headers because of both heat and...
