Separate names with a comma.
Remember Jetsize is only computing the flow data from what you put in at 8000 or 9000 rpm in high gear. It is not maintaining anything or showing...
The Jetsize software is designed for the fuel pressure sensor to be before the BV because there is a slight pressure drop across the BV and it is...
It is normally 8-9 on a Roots blower and 20 on a screw blower. You can raise it on a Roots blower but you will idle richer so you have to set the...
Don, it would cost you big bucks $$$$$$$$$
as far as the flow sensor you are only concerned with the total flow of fuel going into the motor. The standard configuration is to block off the...
It will change in value if a fuel bypass turns on or off or pump loop poppet opens.
Wow, so you can smoke Frank Manzo or Tony Bartone or Tasca with any of your Outlaw FCs? That means you can run a 3.58 to a 3.60 sec at 211 mph in...
MotorPsyco, that mount has nothing to do with the retarding under load. All magnetos have an inherent characteristic of retarding timing as the...
If one is aware of the magneto loading effect that all you have to do is advance the timing on the mag 4 degrees over what you are currently...
The problem with this type of mag is that it retards your ignition timing when the mag is put under load. If you want a mag the I would suggest...
What blower is this? I haven't seen too many that will give you a vacuum in the intake manifold at idle and yours is a small motor so it should...
Talking about the floaters. Not sure you can get the discs there but you can try to get as close as you can.. If I remeber corretly you can take a...
I totally agree with Blown375 it is not the valve guides.
So why does 2 stroke save your motor and gear oil doesn't. The amount that leaks is pretty small. Both Rich and TJ at SSI told me to use gear oil.
Peacemaker a couple of questions for you or anyone else out there. I have heard this about 2 stroke oil for many years but if I talk to SSI or...
Yes you should be using a coolant while cutting the floaters or they will warp. Before you turn them over and cut the otherside they should be...
CS-1 is 150 psi and a CS-2 is 250 psi
SSI and other blower makers want you to use gear oil for the gears. Synthetic gear oil works great 75W90 GL5.
Make sure that you have the idle return line blocked off coming out of the BV. Common mistake is to leave that line and poppet connected. this...
If you have ever watched a valve spring on a Spintron machine you will see why the tail ends break off. The spring can go into oscillations at...
