Separate names with a comma.
Tell us more about your clutch. What make. What disc compound. When was it totally resurfaced last? How thick are your discs? If it is a Crower...
Mike, do yourself a big favor and turn on that Low Speed leanout. You are acting like the Low Speed Lean out is like a High Speed Leanout on a...
Call Noel Manton about his new came with a special profile that stops the bounce on let down
My bet would be on the cam lobe ramp being so steep that the lifter roller can't stay on it so it is bouncing just a little on let down and...
Lash caps can be beat up if the end of the valve stem is worn so the lash cap moves side to side or rocks. It can get beat up if the valve...
Arev you sure that is VA and not VL or VU for tray Upper and tray Lower
Put the power switch between the capacitor and the 8973 instead of before the capacitor then you it will shut down immediately
Josh, there are several reasons why MSD recommends using the capacitor on there systems. One reason is to filter the 12 volt input power and the...
As far as EMi is concerened the only difference between an aluminum box and a steel box is that the steel is ferrous which means it is magnetic...
There are several ways to do and observe the rotor phasing but nothing better than carefully drilling a hole in a cap and making it larger with a...
I agree that you hear the slack in the mag generator drive hit when the magnets pull it around but I have never used it for anything.
1. The correct initial static timing point is with the rotor turned by hand as hard as you can turn it and the rotor pointed at number one post....
Applying 12v to the dark blue resets all to the ready set go mode and then taking the voltage away starts the retards and timers Jody. Is your...
Well as much as I like the Power Grid I have to admit that MSD let us down by not having more than one time or rpm activated switch that can be...
Hmmm. If you use the throttle switch then how do you reset the box before you check the timing? How do you reset it if you want to use the burnout...
From Akerly & Childs on the Extreme rings the start off recommended gap is .007" times your bore for both the top and the 2nd ring. The oil's are...
No problem, any time 12 v is aplied to the dark blue wire it resets the box into a ready to launch mode. Normally the clutch switch is adjusted to...
That Leander's Bros spring checker/changer is the best there is.
LOL he has caller ID and will not anwer for some people:p:p. You just have to keep calling. Other than being at the races Dave is the only guy...
You should not have the port nozzles open when staging. You should look at what the fuel pressure is at stage and adjust the port poppet so it is...
