Separate names with a comma.
Kerry, can't understand why you want to do that and bypass the cooling and lubrication of the blower. Also that will mess up the fuel distribution...
We were the maroon G-Force '68 Camaro that went to the finals and ran against Jimmy Keen. During the Finals the front wheel bearing broke so we...
If you had stopped by at Adam Flamholc's PM from Sweden and asked me I would have gladly shown you and explained it all to you. Moving the fuel...
I think the early description of the Cleveite "M" bearing is incorrect. The "M" bearing has a nominal 0.006 in. single thick babbit layer on...
Put a heat lamp or two over the block all night then they will come out real easy. Then like already said put the new sleeve in the freezer for a...
Jody, do me a favor...get hold of an ohm meter and check the resistance across all those crank trigger sensors including any know good ones. They...
That's funny Jody because if I remember correctly you have bragged on how Greta the Leant and the Spud ones are. Seriously the odds that you lose...
Finally got to a big computer. Tired of typing on my phone. Ok, with an alcohol motor you do not soot the plugs on shutdown like a gasoline motor....
Any thoughts given to If you click it off at high speed then you shut the Powerglide pump off and have no converter cooling and no tranny lubrication.
Probably a better memory than your Gov Perry (lol)
The problem using Ti for wheelie bars is the welds will keep on cracking. To weld Ti correctly the joint needs to be totally enclosed in a inert...
What is it that is reading off. Temp, humidity or barometer. I can tell you this that everyones weather station reads differently. I use a...
If the injector hat is slightly smaller than the opening the yes you can grind the hat if it is thick enough to match the opening. If the injector...
Having an injector hat larger than the inlet of the blower is probably the worst kind of mismatch. The largest percent of air that matters going...
For that amount of money I believe I would give Darren at DMPE the exact size and shape of the bottom of the hat and the opening in the top o the...
It will not lower the temperature but depending on how much of the PSI top opening you are covering up now then it might increase you boost.
My wife tells me the same thing and you and she must be right. About two o'clock this morning I realized I had a memory failure and had stated it...
You are argueing with applied physics not me but it does change with the amount of HP and or the amount of weight. So what is the pulley changing...
Maybe the NRE heads are different to the 7/8 on rocker arms. Yes, I had a great time with Adam and his crew. Had a real hard time adjusting to the...
Graham, 5/6 stuff will bolt on to a 7/8 head but the valve geometry will be off. You will have problems with pushrods and other valve train parts....
