Separate names with a comma.
I don't know. Will have to ask Adam. Why do you ask?
It is caster AND toe in. Real positive caster causes that shimmy and it is worse if the toe in is not set correctly. Make sure you check your...
No, it is a recreational vehicle. I got air brakes on my motor home and don't need anything special here in Georgia. Some states require you to...
Whose car was it at PRI?
If it gave more power by having a collector on a blown engine I can tell you that the TAFCs and the ProMods would be running them.
I have never seen a collector header on a Roots or screw blower car unless the rules require mufflers. Turbo cars use a single large exhaust pipe....
Hi Justin. I agree that it is easier to read from the Power Grid because it is a lot smoother. It is easier to see the changes in timing as the...
According to Racepak the recorded timing data off the Power Grid 7730 is only the mapped data that is being sent to the coil. This is normally...
Try this: Reichert Engines Inc. 203 S Gould Street. Owosso, MI 48867-3249 Phone: (989) 729-7867
The only way to record actual timing in the past was via a separate crank sensor because the mag controller and the Racepak were two independent...
Yes, the 2 Step is in the Power Grid as in the 8973. You need to hook up the blue wire to either box either to the clutch switch or the transbrake...
No doubt there is an advantage to the Power Grid's direct hookup to the Racepak for recording timing and retards and things. Also you don't have...
Only through a relay.
It has to go through a relay. You cannot pull big current flow through the 8973 or the Power Grid.
Thanks Patrick, that saves me from writing the explanation and yours is easier to understand using "swamp coolers";).
Give me some time to get hold of the guy and have him write up an explanation at a level I can understand (lol)
The percentage of fuel talked about is only for Roots blowers.
The whole trick is to stop a dirt particle that is larger enough to block a jet. The screen seems to do an adequate job. The inline filter does...
That would be great but there is a point where the cooling effect stops after putting so much alcohol into to the top. I had a fellow engineer...
Try for as much in the top as possible. The only thing you really need port jetting for is to balance the EGTs. 65-75% in the top is good. The...
