Separate names with a comma.
I believe that was covered above
That is deep, yep Zen.
Big changes in water grains can cause that. Going from 50 grains to 100+ or reverse.
Chuck, something else changed. Do you change main jet size based on changes in Density Altitude? Did you have major water grain changes? The...
The plug only shows what happened some period of time before shutdown so it depends on the fuel curve of the fuel pump and other indicators....
Mark even if you position all the probes in exactly the same position they may or may not be correct. I have seen them all in the same position...
The NGK B9ES reads the same as the NGK 6061 and the NGK R5672a. If I was you I would switch to the B10ES just to make sure the center electrode...
I just tried it by clicking on the link and it worked great.
Thanks Jason. Bill if after you read it if you have any questions then let me know
It is more important to read plugs than to use EGTs. To many things make EGTs incorrectly read from cylinder to cylinder. Have you read my...
The safe EGT in a quarter mile is a max of 1050* In the eighth you can go 1100*. As far as the max that is hard to say because it is dependent...
Yes, set them both at 25 degrees and the rotor phasing will be right on. It is smart to use a crossover switch. Crank triggers fail and nothing...
Understand your point and it is valid, but I think it was a more of wanting to know the flow so to buy the correct size pump.
Thanks, I had a great trip. Flew to Copenhagen, then across the bridge to Sweden. Stayed at Adams house then we took the FC to Alastaro, Finland...
My flows listed are from Waterman
Can't give you 9000 but have the data for 8000. 800 pump flows 5000 - 11.0 6000 - 13.2 8000 - 17.4 900 pump flows 6000 - 14.6 8000 -...
Here we go again. First the 8973 did weird timing and now the Power Grid. First understand that neither has the capability to add timing over what...
Ron, if the recorder was sitting on rubber mounts then normally you can accomplish the same thing by grounding the box with a separate wire to the...
You don't need big red top Optima batteries. Two lightweight Braille batteries or equivalent will work. If that motor doesn't start with the first...
It will not start it. It is voltage that controls starter speed not amps. Amps allows you to maintain the starter speed.
