Separate names with a comma.
Boxes Thank you Frank !!!!!!!!!!!!
Bearing Can't you run a bearing in the flywheel? But call Nick. DO Not run it with the wrong bearing size. I did one time, for about 3 seconds....
Does the rpm port on the retard box see the same signal as the port on the 44 points box ? Need to run a RPM shift box and a two step but have 2...
Boxes I am sorry for that reply, I meant to start a new post, and i didn't x out. I will try tat again. Don
RPM ports on boxes Does the port on a 44 box for the rev limiter, see the same signal as the port on the Retard box. Need to run a RPM box for...
O- Ring You can,t just use any kind of O-ring material can you? Also, there is a specific theary on how it works isn"t there? Size, compression...
working 3 phase WoW I thought working on the race car was confusing at times. Good luck Dave. Let me know when there is a good time to give you...
cam end play I try for 0 to .004. Just did mine. Had to machine .056 from pump extension to end up with .003 with bearing and shims on each side....
clearance I would think .090 + .120 would be plenty, so you can change gaskets and move the cam around a little. . Could be wrong . Don
v to P clear. What gasket thickness do you use when checking? Thanks Don
clutch Have you ever seen a clutch come apart? Let me know where you will be so I can stay away. That recert isn,t just so they can get your $75....
tube retainers Is it a rule for you? Wizzards and other company's sell retainers to hold the tube in if a plug decides to exit. It is a safety...
timer box Call Hartman, but I don,t see why not. I have seen Automan, Aft boxes used on timers. If you are looking @ the Box @ RBS, call me. It...
mats So fill us in on the info. Don
Combo I am sure they changed a few things with the lower nito percentage. I think the $5000 number may be close to finding out a general tune up....
No- Money Most of us weren't born with a silver spoon. Go to the aces, talk to people and see if someone in the same position would like to...
torque I was told by rep. engine builder, non h-11 are Val. 55/ top 145/ bottom 125 but he never spec. if it was cast or billet. just h-11 or...
wrench Fabricate one. If you know what you need. Don
starting What do you have for a MSD Ign? If you have anything except a 44 Mag you may need to start it with the switch. Don
tool Call MTI. for the tool and parts. Or Alan Johnson , T&D Wizzards BAE. and see what they say's to use. I use the MTI both on head and...
