Separate names with a comma.
Have you tried it on the mag instead of the crank trigger? I doubt that is too much distance. There is something else hooked up wrong.
16 port nozzle systems are almost non existant for two step cars also. I think when you are talking about being lean in the top of the screw...
I have never seen that happen. Maybe because all the screw blowers that I am associated with have the correct fuel tuneup. The only damage I have...
Yes with both the MSD Power Grid and the Davis init
It is only for cooling because there are no stripes so nothing rubs
I believe it should be always in auto
Oil without metal particles in it is non-conductive. Oil is actually used as a insulator in high voltage applications. At this point it is worth...
Somebody must have dropped it. Don't take this wrong but not sure I can understand how bent shaft could cause carbon tracking on a spark plug...
Mark, my question is how you would bend a shaft inside the generator? Not trying to argue but to ask a question. From what little I know is that...
Most important is when it is hot. As far as how tight is a matter of personnel preference
Mark, just for interest......how would a ProMag shaft get bent. Surely if that was the case the OP would have has trouble before he increased...
That is an interesting problem. Logic tells me that for some reason it is hard for the spark to jump the plug gap so it is finding an easier path...
Are the plugs carbon tracking on the outside down the insulator or carbon track ink down the porcelain of the center electrode? How old are you...
For the Jetsize software call Sean Brown at Accelaration Enterprises in Alberta, Canada (403) 938-6200. No website.
Having no poppet valve on the port nozzles would only make a difference when the motor is at idle rpm. Once the motor comes up under load then all...
Swap them after every run
If all the alignment is correct and it is adjusted correctly then you may have a fuel or ignition problem that us causing a backfire up into the...
Screw is way more efficient than a roots blower so requires a different fuel curve. Screw has no stripes to wear out so boost remains constant....
Corey, I find that 65* f is the switchover point for using a gas and meth mixture.
Either way. You can buy a 24 charger or charge them as a 12 volt. CSR make a special box so you can charge them as a 12v.
