Separate names with a comma.
The only reason you are spraying fuel into the top of a screw blower is to cool the air charge. The screws are not heated by friction.
You can't post pictures on this website unless you have paid for that level of membership. Same goes for having an avatar.
Call Lenco and get a dummy shaft for the front section. Then pull out the front Gearset and replace it with the dummy shaft. You also need a plug...
Ok I saw your picture and just talked to my friend at Lenco and he says the length of the amount of splined shaft showing that fits into the front...
I agree it is probably a repair sleeve for the front seal area. My concern would be how far the input shaft is going into the transmission. If...
I am confused by what you mean as to the "collar" on the input shaft. There is no movable collar on the standard Lenco input shaft. Maybe somebody...
Are you referring to the point that the front seal rides on the input shaft? If the holes for the magnets are right where the seal rides then I...
Wayne, you need an ice chest with two little oil coolers inside and two pumps on it. Then you need two hoses with quick disconnect couplers on...
USA country code is 1. So it would be 0117072261556. Is that what you mean?
The guy that builds them is Derry and his number used to be 707.226.1556. I haven't talked to him for a long time. Hope the number is still good.
How much it would change the launch would depend on the converter and gear ratio and how you are leaving. You are right that it doesn't make a...
Referring to the Bruno Converter fluid pressure adjustment on the drivers side of the unit. Not the dual pressure unit on a turbo unit
The other option is to adjust the converter fluid pressure on the Bruno. You can go down to 110 psi which will soften the hit. In case you don't...
Another factor in selecting a launch RPM is if there is a timing control on the motor. If no timing control computer then it would be a lower...
I like using a stainless steel mesh cone screen that fits into the BV inlet fitting. It is held in place by the inlet AN fitting. It is available...
Stop and think here what your fuel pressures are during a run. Most everyone use lean out poppets set between 40 and 70 psi crack pressure. Don't...
Well, got to say this. No doubt the RPM is great and the support is great and I have had one BUT and I say BUT I much prefer the Racepak V300...
That's interesting. Have you done and cylinder leak down and a valve spring pressure check?
Are you taking out timing when on the Two Step if so how much? Are you pulling out fuel on the Two Step and if so what jet are using? When you...
I agree with John. I have had the best success with the Computech RaceAir Pro.
