Separate names with a comma.
Yes you are going to have to use the tra transbrske button to move the forward/reverse lever. That is mandatory. Have you thought about putting...
The pressure of a pump when installed on a car is dependent on engine RPM and total orifice size. You can raise the pressure by decreasing the...
Blown apex I have been having cross over switch failure both on the Leahy and MSD units. I suspect it was because the switch was hard mounted to...
Greg that switch that RBS is recommending would be really great if you used a crank trigger. It would still work if you just ran off the mag also....
The MSD relay kill switch works just find and is very reliable. Not sure putting it on the steering wheel is a good idea. Ours is located on the...
Home Depot sells a very large roll around Drum fan. You can get them in several sizes. These are industrial work site fans. Get the biggest they...
Tom's Differentials has both a great pumpkin and great gears. Used by promods and ProXtreme with great success.
Your DA/ET computation can't be linear if you never change the main jet. Ok let's say that your main jet you have in the car is perfect for 1000...
Since you are not changing your main jet a lot depends where your tuneup falls within the corrected tuning window and most likely is what is...
Are you changing Main Jet based on observed DA? Do you look at Water Grains. Do you have a Racepak that shows if you had any tire spin on launch...
So does that total include a quart in each section since it is a three speed. Or do you put a quart in each section then the 8 quarts in the...
The Points Box doesn't know the difference from one cylinder to another. It just fires at a rate that the trigger tells it. The only thing that...
I do not trust EGTs. We have discussed this several times on the forum. Trust what you read on the plugs. If the fuel is good then I would sure be...
Go up on RCD's website and there are pictures showing the difference. The top of the teeth and the valley are more square on one and rounded on...
you never said if you use a Two Step or not. Without a Two Step I change the belt after 14 runs. With a Two Step you might get three runs out of...
Yes the cadmium burns the same but the timing line or "blue line" will fall in a different point on the 6061 because the ground strap is shorter...
Dave, a couple of questions. The Monitor says Step 1 retard on so I would guess you are using that to adjust timing if I remember correctly. The...
I agree. They are both specified as "R" plugs meaning Race. Can't understand the difference in price other than they can get away with it. No need...
What kind of plugs on eBay? R5671-10 or R6061-10 or what. I believe we are all talking about the R6061 plugs.
Have you tried connecting it all up then open Datalink and go to Settings and Scan Comm Ports and see if that helps.
