Separate names with a comma.
Yes, a smooth low idle does seem to be an advantage of 16 nozzles.
Yes, that is correct. I have jet area and GPM charts I have corrected to methanol.
I still have 16 nozzles on the PX Viper running in Sweden and it has a converter. The reason it is still on the car is because that is the way it...
Port stagger on a screw blower depends on the design of the intake manifold, the percent of overdrive and the biggest factor being the plate...
Be very careful of the Ralph Gorr website Jet Flow Charts. According to Ralph his GPM Flows at 150 psi are with water and not methanol. There is a...
Ok, if no crossover switch then have you tried running it off the mag vice the crank trigger. If you are interested I know where there is a brand...
Do you have a crossover switch for switching between the crank trigger and the mag. If so I would highly recommend make a run with the switch out...
If the motor is that rich that there is no burn on the plugs then use them again because it is not that critical until you start burning off the...
There is more to the weather picture than you think. First of all the Density Altitude is 3641 ft. Time for a transmission gear change to bring...
Try this http://terminalsupplyco.com/Store/Default.aspx?CAT=TERM070&PCAT=61820#Categories
They are on PST time so no point calling in the morning if you are on EST. That number is good. Mondays and Fridays are bad days if they have been...
I have a picture of plugs with 30% cad burned off which demonstrates what I talk about in my article. PM me your email address and I will send...
Then it was not wired correctly. If you shut off power to the Grid or 8973 then the ignition system shuts off because you have broken continuity...
Monaco never put a high amp electrical outlet off the generator anywhere. The best thing to do is to have an electrician install a 50 amp outlet...
Most MSD systems will function down to nine volts. Have you tried running it without the crank trigger and using the mag?
Mike, you say you have a crank trigger so do you have a crossover switch to switch between the mag and the crank trigger? If so how and where is...
It is more important to care for the Bruno than the converter. If you use the wrong ATF in the Bruno/Converter you will burn up the transbrake...
PSI Quill shaft will break on you. The RCD one is great but you have to change too many parts. Haven't had a Lenco shaft break yet. If you are...
Make sure you use a Lenco quill shaft.
Two problems. The lower pulley gets so big that it hits the fuel pump extension. Second problem is that the upper pulley gets so small that the...
