Separate names with a comma.
You need either a -8 to a -6 or -10 to a -6 adapter to keep in your toolbox so you can check your poppers on a regular basis
Screw the poppet into your leak down tester and slowly open it while listening for the air to just start going through it which is called crack...
so what is the idle return poppet set at with the fuel pressure gauge attached? What is leakdown set at and what is the idle rpm set at?
Well the fact that all the plugs wires read good resistance does NOT mean they are good. The biggest problem with plug wires is that the...
Yes, spray PRIZM in before each run. In a Roots blower you can't put in too much PRIZM . According to PSI you need to be careful on how much you...
The blower motor seems to work better when the motor is loaded and pulling from the around the high torque rpm to the hp peak rpm. If you use a...
Most common reasons are bad plug wires or coil wire or if you are using a crossover switch on the crank trigger then the switch contacts are...
Had to think about that. One thing is that the Digital 7 does not have the ability to record the ignition during the warm up or run. I have used...
NGK R5671a-10 with that kind of boost. Your -9's would probably do just fine but better to be safe with a -10. The heat range doesn't change your...
Thanks Bob
thanks but Dunn is out of Argyle, TX. It is George Sitko I needed. Took me awhile to remember.
Who is the guy that builds the black offset mag drives in Los Angeles. They kind off look like a PSI mag drive. If you have a name and phone...
So this setup has worked in the past? When you trigger the retard are you doing it from a clutch switch or TRansbrake switch? Does the EMI box...
For a converter the 1800 is better. For a clutch 2000 is better
your main jet does not control your idle mixture.
That is the way I do a leakdown.
i think an idle check poppet for a Roots blower car needs to be at 10 lbs with a .010-.012 air gap on the blades and a leakdown of 82-84% with the...
Ok, just called Jeremy at BAE and he says that they were getting hit with malware from overseas so they locked out everyone from overseas. BUT if...
I just tried it again and it worked for me. Maybe there is something about being in overseas or in Europe. I will call them Monday and ask them
Do you put silicone sealer under the counter sunk screw heads that hold the back plate on? If not do that and see if the leak stops.