Separate names with a comma.
Bob auto makes a real trick one...and also REMEMBER this is not an rpm controller if you think it is and use it as tho..you will kick the rods...
A little humor never hurts:)..Dave.p.s. this last bill is getting hard to get from themm...this sucks
Darren...Darren...Darren...I haven't forgot you I will get it to you when the schumachers send me my check they have 9 cases I sent them that I...
I've been waiting on a check for 3 weeks and nothing yet.and they said it was sent out!!!..and this is a big name racer..if not here tomorrow...
what you wanna do is on the back side were it is preferated put a large bead of silicon on there also I have put a 10/32 screw with a big diam....
hey mike found out the trouble with the davenport i had it open and then opened it again and didnt know it..so problem solved good talking to you....
piston fail
use a go no go tool..and remember always back off the torque wrench whe you are done with it.Dave also if you have time when you knock off the...
call Tom Conway..his cell # is 918-630-5439..his past and present record says it all..Dave Lowe www.myspace.com/daveloweswr
hey Jeff pm me with a ballpark figure..thanks Dave
when you set up a fuel system it all starts with a base line...as in total hat area total port area and what your pump flows, how many gals. you...
that is the guaged hole in the pill..when you set up a fuel system you need to know your total hat area and your totaql nozzel aera ..Dave
hey Darren, I have been out of town..when I get things back in order here I will send you some spray..sorry ..and as for 3 inches I think he was...
Moparious, that is were I have mine that way I can see what mu pump is doing..Dave
use ONLY the motor oil on your rod bolts...NEVER use detroit tor. compound. oil the holes ond the threads and washer also the two halfs and make...
iam looking for a bottle..thanks Dave
hey funny car bob..what pump?
ok..here is the latest......my phase converter is rated from 1hp to 8 hp nothing under or over that rating..well with no tech plate on the motor...
any racers out here know about 3 phase?? I hooked up my surface grinder to a phase converter..and I might add my mills and lathes are also hook up...
Yes....................................GONE
