Separate names with a comma.
Gear pumps do not wear very much. The gears hardly ever wear and usually only the end plates wear. After five years a gear pump may have lost .2...
You may need to adjust the length of the top opening to keep the air veocity up. Ask Andy
Racepak uses 300 psi sensors for all those and they are more than accurate enough for racing. Realistically you oil pressure needs to be 200 psi,...
Call Andy Wilfong at Littlefield and talk to him and see what the lowest OD your blower can handle and how much boost. I would guess you need to...
Never have timed it or measured the temps. We grab hold of the line coming from the Bruno unit and when it feels like ambient temperature we...
We use one sold by Mick Synder at Synder Motorsports. It is a wheeled ice chest with a handle and attached to the outside is a 115volt pump and...
I wish it would give you a baseline tuneup. That would be great but don't know one that can do that successfully. If you know enough about tuning...
That is correct but for that price you get great support from Greg Gower plus all updates. I think Jetsize is up to around $600 now and is not...
I have used Jetsize by Les Davenport for years but have now switched to Alky Pro which is a more robust program. Jetsize bases its selection of...
Other than the MSD Grid 77303 being in black does anyone know the difference between a 77303 and a 7730?
I think .012" is right on for a 4 bladed hat with a converter. You are trying to get the idle rpm down to a stable 1800 and with a bigger gap than...
Three main companies make dependable flexplate, Meziere, CSR and DMPE Inc. The normal tooth count is 162 to fit inside the inner shield in the...
but if the intake bolts were loose then it most likely was leaking even if one side was still in place. Doesn't take much of a gap or hole when...
If the intake bolts are loose then yes the boost will force Alky into the lifter valley. The intake gasket has now provably been pushed out on the...
Could be. What rpm does it idle at in gear and out of gear? What converter drive do you have
Change you idle check to 9-10 lbs. This will require a readjustment of the barrel valve leakdown. Normally on a hemi that 9-10 lbs requires about...
Your fuel pressure seems to be too low. Where are you picking off the pressure, before the Barrell valve or after it? The standard is at before...
A nitro car only launches from idle because of the type clutch they are using. And yes you are correct in that if you put nitro engine on a two...
Read your new plugs after a run and adjust the fuel accordingly http://www.dragstuff.com/techarticles/reading-alcohol-spark-plugs.html
I would recommend the Jesel lifters. They may cost more but look at the cost of a lifter failure.
