Separate names with a comma.
5.5 to 5.7 with your setup
Yes both plugs read the same. Something in the gold coating was suspected of causing cancer so they changed the coating. The coating on the 5671...
Are you using a crank trigger?
According to Matt Moore the Lenco expert you cannot unless you have a special case and an adapter
Will is correct, it is cheaper to rent Will and have him walk you through it. Hopefully you have a MSD Grid which makes it easier to adjust for...
So how much was it from them? Still around $895. So the question now is does it have the K-factor scribed on top for use with a Racepak? Homer mak...
It is Greg at 602-908-2316
Normally turbine flow meters are measured in gallons per minute of GPM. 20-25 lbs per minute is only 3.0 to 3.77 GPM with methanol weighing 6.63...
Call Barry at RCD Engineering and tell him what you have and what you want. Most likely they have what you want (530) 292-3133
An ohm meter is only going to tell you if the primary windings are open or good. If the engine runs then you already know that. It will not tell...
Only good way is to replace it with a known good one.
Eric, at idle you snap the throttle at the BV off of idle. It should be a fast response without a hesitation or a blubbering. If it hesitates it...
I find that oil is mostly diluted at idle because the BV is adjusted too rich.
Alky Pro uses all of Patrick Hales formulas. I think that maybe Patrick's is ahead of Alky Pro on that. The reason I chose Alky Pro was that fact...
Even if that crank trigger cable is shielded it cannot be routed with other cables and has to be kept far away from the coil wire and the plug wires.
I have never seen a 8973 mess up. Normally the cause is from using an unshielded or ungrounded shielded crank trigger extension cable to the 8973...
Steve I can call Bruno Monday and ask if it can be easily updated. A good starting point on pressure is 150-160 psi when the engine is steady at...
Steve, I would check the runout on the converter after you install the flexplate. It would be very unusual for a Chance converter to have runout....
Every round if it is a Roots. Screw blower just once a day first thing according to Kevin Cantrell at Cantrell Superchargers because it has no stripes
Putting a flow meter in the system is really good BUT you need to do something with the data obtained such as the methanol fuel tuning software...
