Separate names with a comma.
If you leave the transmission engaged at the finishline and let the motor slow you down you may have to re-torque your rod bolts every two runs....
I can just imagine but you had Mertz teaching you. Wow.
Nemo, Incase you didn’t know, Andy works at Littlefield Blowers and is an absolute expert on Roots blower. The problem with spinning a blowe...
Yes, just shout of power to it
Let’s wait and see if somebody on this forum can give us an estimate of the amount of boost at 31% on a screw blower then we can go from there on...
You have to know how much boost difference there between the two OD’s and multiply that by .34 to find the GPM difference then subtract that...
No problem. One thing is not to use a relay for the transbrake. It doesn’t need one and the relay will slow down you reaction time plus they are...
I think the 2.5 lb bottles work well. With the Bruno you would need to change it every four runs. The Bruno uses a lot because you have to keep...
It would seem to me that if it was caused by detonation then there would be evidence of it in the bearings and maybe pinched rings but you said...
I understand that if you torque from the middle and out the ends of the heads lift up a small amount and will not go back down with full pressure...
It is recommended by BAE and everybody I know does it from the outside going in and the reason we do it this way is to stop blowing head gaskets....
Another question then. Do you torque your head bolts in the conventional way starting in the middle and working out or do you torque them starting...
So if you are pedaling and blowing head gaskets then do you have a WOT switch that actives timing or fuel control? If so then that is most likely...
Call Eric Lowe at Racepak. He is the V300 guru. 949.709.1572
Most hydraulic shops can make them also
I would never call dividing boost by fuel AFR. It just happens that the answer falls within the range of real AFR. I would say that in your...
I agree 100% with jay70cuda. With a PSI screw blower you want the biggest valves your class allows. If you have a Roots blower then smaller valves...
It doesn’t error either way. It does what you tell it to do. My recommendation is to find your best run in the past that you have weather and fuel...
Alky Pro (AP) has pump loop with poppet pressures, fuel leanouts and everything else that is required. Another thing AP has is a correction to the...
You can use it without a flow meter and use the GPM estimate that the program gives you which will be pretty close. Treat that estimate as what is...
