Separate names with a comma.
A. Heavy bolt pattern on the bellhousing will not match up with a hemi unless the bellhousing has a dual bolt pattern. Call Jeff Bohr ((734)...
Trevor what transmission with how many gears are you using?
You should check and adjust Bruno pressure with the tranny in neutral and at 3000 rpm so the needle is steady. The normal is 150 lbs of pressure....
You should need more than 5 degrees. On our current motor we don't pull out any. Just spin it over for a two count and hit the ignition. Never...
What does your Bruno pressure read at 3000 rpm?
Have in the past. It works if the rotor phasing is off to compensate for it
It is not just the mag but also the plugs and ignition wires and that is why the Racepak is normally mounted on the bar just in front of the wheel...
But your Racepak maybe too close to the motor and the high voltage interference from the mag and ignition wires. If it suddenly stops recording...
Hi Trev, should be no problem because there is no high voltage in the Grid
See if this gives you what you need http://www.wallaceracing.com/calc-rgr.php
You cannot read Autolight plugs for combustion chamber temps. You need to switch to an NGK plug probably a R5671A-10 or a 6061-10. It takes fuel...
13 GPM with 43 lbs of boost at 1200 ft is lean. i would start out with 14.4 GPM and get a plug reading and go from there. A lot depends on the...
How much boost at 8000 rpm. When you say 13 GPM needed then what DA is that at and what rpm? The standard pressure out of the pump before the BV...
Most likely that is the problem. The spark is weak at starter rpm. Try changing your rotor phasing so it matches your start retard timing and see...
You can also buy the special short squared off nozzle from Good Vibrations
K8 had a real bad record of rotors cracking and then blowing apart not sure I would ever buy a K8. K11's are really good for higher ODs and the...
You can fill the front of the back with that liquid plastic and shape it for flow. If you talk to DMPE or Dave Koehler they can probably tell you...
The opening in the top of your blower is also that big? If it is smaller then the incoming air is going to hit a real big ledge and create a lot...
