Separate names with a comma.
Oops, M&H T/F tires. 12" of course.
I was told to run my liners about 45 psi and the tire about 6 to start. my ride is a 200 7.0 FED. Opinions?
I also ran a .060 010 block, but after 78 passes (18-22% od, 11.5:1) i had four cracked cylinders. However, that block had been ran hard for...
My motor was a 3970010 small block, bored .030, 11.33:1, with 15-19 pounds of boost.
I've ran a filled stock main cap 010 block to about 1100 at the wheels. It never showed signs of failure. It had a stock 3.25 GM steel crank also.
It would be nice to sonic a few bars and see thickness. I have a FED and a short bar, so i can't help much, but good luck.
LMAO. I like it.
Great Job Laurie! I'm sure you'll find something to do for 5 weeks.
I have a TBS tented floor intake on my blown SBC. The tent is standard, it has no variations for ports.
Agreed, I didn't mean for that to be a complete starting procedure, just trying to help & answer questions. :) A/F is one of the most dangerous...
It's mostly their setups. We use alky and a squirt bottle to start the car when it's warm, but on the first fire up to get heat, it runs on a...
Yes. I run most all the fuel up top, then tune plugs with the ports.
A bowl of water, and when you get more than the initial bubbles, is the opening point.
With more OD, the fuel to the ports should be increased to help cool the air in the blower to enable it to be cooled off by the time it hits the...
I've been running pump limited classes for years, so we usually don't get over 29-35%. I know we have no heat issues at 35%. SSI 671, 464...
Craig,I've heard in the high 30's the effeciency falls way off.
Cool. thanks for the feedback
For my SBC, do i need valve seals? I ordered my valves today, so i'll be assembling my heads here soon. I've always ran them before, but I've...
