Separate names with a comma.
Jason, With that much boost, what do you run for piston pins and rods that make it survive? How many runs to you normally get on each before you...
Lots of good info guys, appreciate all the input. Looks like the nod goes to the cooler over the bypass line for longevity. Have a spot right...
Running blown alcohol with an automatic, 6.50 quarter. What are the pros and cons of running a trans cooler vice just a bypass? Trying to save...
Short deck 548, 4.530 x 4.250, 6.525 rod. JE piston with 1.120 compression height. Either Childs & Albert or Manley Super 70 Nitrous rods.
I'm having a tire/rim fitting issue in my door car so I need to find out if any of you know the tire bulge difference on different size rims. I...
If you are bracket racing, just use the industrial grade methanol. I have used it for the last seven years and have zero problems with it. The...
Here ya go. http://www.rcdengineering.com/chart_8nav.html
That's the ultimate way to go if you have the $$$, the New Century is within reason and would be the best besides the CN billet. The issue is...
No question, get the Dart. It's heavier than the Bowtie or Merlin but the walls and decks are thicker and you can get away without filling it....
Follow the thread, good advice from the front-line. Ditch the block if you can aford it and get a Dart. Can't build anything on a weak...
JR comes through again, appreciate it. Mine is a B because of the ridges and is in the 140's for the serial. I'm sure there must be a...
Not mine but I saw this: http://www.racingjunk.com/post/755864/FABRICATED-9-INCH-FORD-HOUSING.html
Besides calling SSI, how do you identify what I have. I just picked up a 14-71 that isn't anything special but just wanted to know what it is....
Thanks Bob for the advice, I appreciate it. While this probably (?) doesn't apply to my issue, I thought this may be of interest to folks that...
Thanks to all, After these posts, I went back and looked at some historical EGT data. Up to the end of last year we ran a locked distributor...
Thanks for the ideas. I have swapped EGT's and that is not the issue. I've changed distributors including the cap and rotor (in addition to all...
Looking for a little help here with my EGT readings, this is a problem that just cropped up. BBC 468, 11.65-1, 8-71, Bird, 58 nozzles, 33%...
If you can get away with a 12 volt, the Optima 31T will do the job with no problem. It is a little heavier at 62 LBS but you will only need one....
Thanks Mark. Tom
Thanks John, just need to see if I can get my door car rear "un-tweaked". It is one of his housings. By the way, that diaper I got froom you...
