Separate names with a comma.
I've known two guys that used a large Bimba cylinder hooked to the clutch pedal in conjunction with a MAC valve to activate with a button....
I would think the 1.80 first would be going in the wrong direction for a fuel setup unless you had a tall enough rear gear to make it think it was...
Most local tracks don't carry nitro insurance on a regular basis, although they can usually get a rider for special events or with enough notice....
Sean, The contact guy in Colorado is Tony, # is 303-783-1290.
Sean, Only one I know of is a guy I've talked to on Nitromater, Buzzz Miller, him and his dad Bobby run a CIFCA style funny, seem to really...
Possibly to get more valve to valve clearance on overlap to run a bigger intake valve or more intake duration. Hemi's have never had a problem...
Medic, You may already know of the site, but check out: www.Racingjunk.com I lurked there for several months and wound up with the car in...
It sounded like what he was needing to do was close the rpm gap up on the gear change, going to a taller 1st gear and shorter rear gear should do...
I'd like to hear some discussion on this too, I'm new to a clutch setup this year, so far I'm getting about .005" per pass, thinking that's just a...
Will, would there be as much advantage with a milder tune-up deal like mine with a Mag III, obviously I've been in the dark ages, but until this...
Danny, My engine combination is pretty old school so I'm almost afraid to recommend too much as I'm running a lot less boost with a Supermag...
Danny, Lugnut hit on the main issue and that is the need to know how much compression you've got along with the amount of boost the PSI is...
I do believe you would be safe with a N/A nitrous setup at 4.50" bore in a solid block. On the other hand, being budget minded, I would hate to...
I have a Stage VII tall deck that is bored 4.510, so yes it can be done. How strong the sleeves are at that thickness, I have no idea, I bought...
Brad, The large gaskets from Sassy are 9" long (about an inch longer than needed for a tall deck) 1" wide and about .455" thick. They will...
Brad, The ones I got from Sassy were actually a little long and can be trimmed to fit, whatever the material is, cuts very cleanly with a pair of...
Brad, the tall deck Veney combo takes a little wider end gasket (side to side and front to rear) than most standard setups. If yours is like...
Sean, Here is a link to a basic hat system in the Kinsler handbook. There are others, just look in the Index for the pdf download....
This one looks a lot more promising. http://www.bcrproducts.com/caps_and_girdle_system.html
Here is a link to one of the girdle systems, but the one I'm thinking of was about 3/4" thick. I'm still looking for the link to that one....
