Separate names with a comma.
Looking to use a fuel flow meter in my setup, I still need to buy one to work for my Edelbrock Data recorder. I'm using an Enderle K barrel...
So what is getting the re-cert? The flywheel, the hat and the stands? Anything else?
By far the best out there!
And the same to you and everyone else!!!!!!!!!!!!!!
I've got the same thing and feel safe in it and can't feel it. The only thing I needed to change was going from a standard Stroud Harness latch...
The center is the best, right down by the deck. My Alan Johnson heads have a tapped hole right there just for that purpose. I've run the CHT's...
Mine were short deck factory 4 Bolt blocks (not the factory HP aftermarket) filled to the water pump holes. Like I said, had some fretting of the...
Ran 1450 HP on stock block and stock steel crank, had some fretting on main caps but worked good for more than 75 passes.
Got an idea on how this would work but do you have any pictures of this or plans to make one? Sounds interesting instead of the pounding effect...
Jody, I have just about the same deal as you except I use a toggle switch for the burnout and backup. It engages a relay that shuts off the...
When I was doing mine a bit ago, Dan Olson's shop said 1/2" was fine. When I said I thought that was too much, he said that you need to check all...
When I ran water and copper head gaskets, I always used Copper Coat to seal the gasket and orange Hi-Temp RTV around the water holes. Never ever...
You might try reaching them through eBay. http://motors.shop.ebay.com/papapeter1/m.html?_nkw=&_armrs=1&_from=&_ipg=200&_sop=10 This user...
I use Red Loctite on the snout, seems to work for me but it is a little more difficult to pull the hub off but really not that much more. Tom
Good job Adam and good luck next year. Tom
They are pretty much identical except for the width of the bulge. I use the 18780 because it is a little narrower (20.5" vs 21.4") at the bulge...
Same here. Pre-heat oil for a 1/2 hour or so if possible. Let heads get to 210 on warm-up/run-in and let it heat soak. Have run in low 30 degree...
It's close but no it does not interchange, been there. Sometimes you can get some sloppy stuff to fit but I would not use it.
Dave, thanks. It did not have a number on it. Got in touch with SSI, they changed their phone number again. It's now (216) 676-5800. Anyhow,...
Tore my seal up and looking for a part number for the seal on the front of a SSI snout. It is a double lip, 1/2" thick, 2.5" OD and 1.625 ID....
