Separate names with a comma.
If you are planning on asking Amos to help you tune it, do HIM a favor and call him BEFORE you spend a $ ! He will be happier and more...
I usually don't try to answer these questions as it's like trying catch a greased pig--------- that being said, if you don't know what parts from...
Bullet Cams -----------
I ran a Blown Alky 406 Chevy, similar hp, same size tires with a 2500 lb A/Gas car it had a 1.68 low 2 speed Quicker drive with a 4.10 rear---...
What did the #1 and #2 pistons, and plugs look like ? Was there any pieces of the rod bearings left and if so what color were they ??
So you are talking about the rear main only ?
That is correct. Get a straight edge and hold it against the face of the pulleys top and bottom, then check the idler from the top and bottom....
Have you used a straight edge to check the pulleys ?? The other thing is you can't judge this by just turning the motor over by hand ------...
600 psi ---------------- or more --------what are you building ?
I spin ours on a machine they do the large truck tires on. It is the same as the Snap on Machine all the big show guys have. Or a bubble...
You might want to start by taking the belt off and check the feel of the blower now, if it is still alot to pull with a 18 inch or so long bar...
If you over torque the side bolt it will crack it right now . Some fuel guys won't take them full torque either--------
So if you don't have a flywheel with carbide buttons and you buy one of these rings to attatch to your motor plate, how much clearance is too...
Are you making sure that when you tighten up the front support bracket that you do not pre load the bearing ???
Is this a blown gas motor ?
Gotcha , I read it too fast :p
Can you install the manifold again, tighten it down without the blower on it. Then take a pick tool and see if the gaskets are squeezed all the...
Have you checked your heads, intake ports, if they have a push rod tube protruding in to the port it might be cracked and allow the port to suck...
Where is the reasoning for a 1/4 " from the flange ?
yes as long as the one way valve is only in the path to the boost gauge
