Separate names with a comma.
We put the engine in without the blower then install it afterward. We built a rig to put the blower on with the crane as well. (sounds kinda lazy...
Mallory Mag x2 on Spud. Fuel injection Enterprises. Give him a call and he will tell you if something is wrong or not. 541-990-2485...
Mag Clamp Good Vibrations has a picture of the Dunn clamp. Go to dragparts.com and look under magneto accessories. Corey
Mallory Mag I do agree with the billet clamps they are the way to go. Sitko makes a nice on also. Corey
Mallory Mag My Mallory mag has never moved and I use an old POS band clamp that I should really replace. Can you turn it by hand after you...
Zoomie Cracking I curious how detonation could crack a zoomie pipe 3 inches out from the head. Don't get me wrong I'm not calling BS I just can't...
Don't be concerned, I had the same fears the first time I did a Lenco. Called them and they said it is almost (read impossible) to get the ratio's...
Video x2 on a cool video. I have never seen a 5" grinder humping a 7" grinder before.:D Corey
Bolt Length Looks like my engine log book is just going to have a couple extra pages in it. No problem, I'd rather spend the extra time logging...
Rod Bolt Thanks Doug, I actually have a stretch guage, As Ken said, I'm tying to get a starting point so when I take the engine apart I will...
Bolt length Not a bad idea, only problem is I can barely see a micrometer, engraving that small a number on a bolt might be a problem;) Corey
Bolt Length I was also hoping they would be the same length because now I will have to chart each rod and its related bolts in order to do this...
It should seem quite apparent that I have a lot of time on my hands:) I was checking them so I have something to compare too when the engine comes...
Finished checking all the bolts and here is what I found. All fall into the following 2.450" to 2.444" .006" variance Any opinions...
I am finally getting to start building my engine and I am measuring my rod bolts (brand new L-19 GRP rods) for a reference. I figured now is a...
Rods X2 on hitting them to full torque. I just looked at the papers that came with my GRP's and it says to go to full torque in one even pull....
Leakage If your numbers are always 10-15% on various ring types, could your heads be the issue? Bit of a long shot but I figured I'd ask anyways....
Leakdown Has the engine been run yet? I'm not 100% sure but I think you need a little seating time before you can expect really good sealing....
Density Altitude This is more for aircraft but it gives you the general idea. http://en.wikipedia.org/wiki/Density_altitude Corey
Thanks Ron. I was most concerned about mechanical interference (wheels smashing lobes)and next the lift. I figured it should'nt change the lift...