Separate names with a comma.
Joe Mondello will our 2009 World Fuel Altered Nationals Grand Marshall and Honorary Starter....
Copied my post from a few years ago....when we had violent tire shake and launch problems....hope this helps... We had a 3.89 rear gear in the...
I use a System One filter on the scavenge side of the dry sump....between the oil pump and oil tank per the plumbing sketch that they...
Sent you a PM on this....call me at 515-727-1444 (ext 11) office or 515-987-4900 home to discuss....I've been through several Lencodrive gear...
Yeah Keith - I knew that the offset bolt was to install the hub or pulley to index it for a timing mark or engine balance issue....sounds like...
I heard that it dates back to the crank hub bolt pattern on early Hemi? (could have been another make engine) - one bolt hole was offset for...
Hey Dale - just curious about using the 1 pc. axle...I just bought a complete M/W 33" wide rear end and it has separate left & right axles...are...
My torque sheet from AJPE says 60 lbs.
The guy that I thought had a spare one has sold it with an engine....so I'm outa leads.....maybe you could find someone on this site that could...
Call Ken Black @ Keith Black Racing Engines on Monday - (562) 869-1518 - he should stock the starter adaptors - I beleive they offer left or right...
I think that Richard at System 1 mentioned that he could make a block off plate from a damaged pump they had laying around....try him at 559-687-1955
We've only lost one rod in 10 years of racing....and it broke on the burnout at KCIR 2007. Sent the rod particles to GRP for evaluation....and...
I have a very similar question....10.5:1 compression - 4.310" bore X 4.500" stroke 526 - 175 CC AJII heads....44 amp mag...25-30 lbs boost....we...
My KB valve covers had clearance issues with valve springs and the rocker stands (AJII heads)....so I machined and ground on them until everything...
On the subject of the lash locks...Manton Lash Locks work great....we don't run ours as hard as the Top Alcohol guys....8500 RPM max....but I...
We use the torque specs & sequence from Alan Johnson...Top row (9/16") first (rocker stands) @ 150 lbs. - then torque inner studs (7/16") to 60...
We use the Lencodrive - very reliable over the last 4 seasons. I think the Bruno is also a good unit...but I'm not sure if they have any bell...
Check your email - I sent you our run log for 2008....similar numbers for you to compare...
OK - I'm experiencing this one right now...so will give ya my opinions: To cut the blank size (without notches) I used a spark thrower (chop...
I don't have a comment on the cubic inch question...but can offer my advise on your combo: Go with the most common, easy to find combination. Just...