Separate names with a comma.
I am with JayCuda on this....check installed height with a new retainer compared to your used retainers....if the old retainers measure .005"...
Starter Bateries - Topeka I was at Topeka on Saturday qualifying as a spectator.....have a question: Why do the Pro teams get to use the Die Hard...
Meziere Flexplate My choice is Meziere billet flexplate - it's manufactured more like a steel flywheel, but really rugged...we have not had an...
Valve Spring Pressure I had a lot of wear in the valve keeper groove until I took Noel Manton's advice and increased the valve spring...
Kevin - we could remove the steering wheel....but if the air lines are tight against the steering shaft there is not enough slack to get it on and...
I have had several of these - SAE and billet aluminum JD2.....both are sold....they both worked well but you really cannot remove the steering...
Larry, Stanke Supply makes these......
Depending on your converter manufacturer, some offer machined aluminum spacers that bolt to the lugs with #10 flat head screws. Marty Chance has...
I was around 325 lbs on the seat and trashing the grooves....and was scared to go much higher on my hemi due to valve train problems on the BBC...
I figured an engine builder would chime in on this one...I pitch them when the margin gets thin from grinding or the keeper grooves get slop in...
We were having awful launch problems a few years ago with too much 1st gear....(1.80 low with 4.30 rear). Frank Parks (Neil & Parks Racing) was at...
Hey Nitro Mas Not sure about injected nitro....but your P/G probably has a 1.80 low gear and the rear gear is 3.50 = 6.30 overall 1st gear...
I have been ranting about less gear ratio on this site several times....my experience has been that if you have an overall 1st gear ratio of 7:1...
I have a U-bend clevis that has a 5/16" hole....1" from bend to hole center....I cannot remember where I got it....this is not the machined slot...
I use the regular Morse style cable and have it set up as a pusher rather than a pull type. Just make sure that you have air on the back side of...
I called Robert Reehl for years before switching and I wanna quote him as saying "never had a customer call and want to sell all of their hemi...
There are several threads on this subject - here is just one......
We use quick pins on a 2 pc wheelie bar and the tubes are sleeved to be double thick where they join.....I built the wheelie bar using a S & W kit...
I asked Bob Blackwell - Division V tech director about this....why we couldn't use quick pins on the wing of our altered but could use them on the...
I assume that your are asking about how to activate the chute release lever? We had an electric/air switch that was plumbed to a cylinder that...