Separate names with a comma.
I know exactly what you mean, and that "test" seems to call for a very large vent.:)
What size is required for blown alcohol. Anybody done any actual tests? Thanks
This is a really good point that many people are not aware of. We use RPV (residual pressure valves) on both ends. Absolutely ends "pumping up"...
Mike... Isn't 45 degrees of rotor travel equal to 90 degrees of crankshaft travel? Wouldn't you be retarded 45 degrees before the rotor reaches...
The same is best. We have seen a difference on the dyno (blown alcohol)with a spread. If you retard a lot, sometimes you have to compromise on...
Jim is just not an e-mail kinda guy. ;)
We use Valvoline synthetic 80-90 gear oil.
Ohio Crankshaft 800.333.7113 Welding crankshafts over 30 years.
Diamonds have done a good job for us.:)
Good point !
Plug gap? ?
JR.......Now let's talk about the modification you have to make after you get them, to make them work. The plates, housing modifications, etc. I...
Clutch switch, set as low as possible, you can also probably lower your airgap.
Finding the right sensors might be the hard part. Also keep in mind that with individual pipes some fresh air is actually reversed in to the pipe,...
The AJ 481 is very easy to work on. Rockers come off in 1 piece, pull head with manifold on. If you have to change sleeve, get it done as soon as...
Build the parts for the 14.71 in the first place. It won't hurt it to run the 8.71. Put in some compression, with a fairly thin head gasket, then...
2.08 with the AJ, probably 1.95 w/ Brad. Thanks
Just curious, what are the average gear ratios, 1st and 2nd, used in an AFC? Thanks.
M/T, beadlocks, 5.75 psi and I'm a happy guy.
Good stuff.
