Separate names with a comma.
That's weird you guys had troubles w/ light throttle :confused: I ran the Biondo unit that hooked to the arm on the blades, and the throttle...
lol...Dave that's hilarious! I beleive it though. http://www.brmotorsports.com/ BR Motorsports are the one's who anodize their mags in...
Buy a beaker and CC the cylinder at tdc is the best way :D Buy yeah, that's basically it. You'd need to know the cc of the piston dome, cc of...
Sometimes it helps to think of things on the extreme side. If you had a head gasket so thick that the surface of the head was above the peak of...
This is probably because as you bring the chamber down closer to the piston, volume taken up by the piston is not linear because the piston is not...
Maybe I should back up a little. Bought a 526 hemi w/ brad fuel heads from a guy. It came w/ new rods still in the box, and another set of rods...
I believe they're "top fuel" rods, they're monsters. However this guy was running them in his pro mod on alky. Isn't that common to run the...
what's the negative's to a long ground strap?
What do you guys usually do w/ rods and pistons that have 10-20 passes on them. Is it worth sending them back to GRP and getting checked then...
Where's the best place to buy Hemi mid and front plates?? I need a mid plate that has chevy bell bolt pattern for a bruno. Doc Enterprises seems...
is there something on there to plug the square hole on each side of the head? That's what I was talking about, I wasn't real clear on that...sorry.
Thanks Bruce
Does somebody make a square plug to put in the fuel heads if you take the down nozzles and fuel rails out? ...or is a mill and some silicone...
Mike i'm surprised you were advised to run a 12, Leahy told me that wasn't enough on my sbf. He said a 20 minimum, but 44 would be the best. I...
Does anybody run a 20w-50 synthetic w/ a hemi combo??? ...or is that a little on the thin side? Running a 526kb, brad fuel heads, 1471 25% over,...
stupid question here....how can a pill size/jet size determine flow in gpm??? Is this not relative to the psi or pump size of the system??? i'd...
Is there a limit to how much timing you can pull from the motor w/out hurting it? ie-launching at 15*and ramping it to 25*???
1400hp....ran 8.5@158 in a 3380lb steel car
Yeah we're very excited about the switch, we were running a small block ford :rolleyes: As far as the trans, we're running a bruno/lenco 3...
Randy is a good guy. I run his stuff, pretty easy to use, and he'll help out whenever you need him to. W/ him you'll get big business quality w/...
