Separate names with a comma.
Absolutely correct ! Clutch parts are really dumb, although people tend to give them magical qualities. :p
We use RCD angle drives, no problems.
Fowler also has the parts for this.
The fact is that either block will do the job with splayed caps. !0.2 is really tall for 4" stroke, just curious about what rod length and...
Yeah, we've been there. Was hoping someone had a better way. Have also drilled a little hole from the bottom and punched them out. At least that...
How do you remove the pins? Thanks
Just for information, Dart has a pretty extensive coating department in MI. They don't advertise this a lot, but can do about anything.
If you got 'em you might as well use 'em. :p
If you find good info, post a link please. The dyno we built was powered by a 283 Chev. Pretty crude.
With a "fat tip" rotor, not pointed. Set the leading edge to just arrive at the distributor terminal at your base timing, then continue to turn...
At the port nozzles will make it easier to diagnose problems and if you are using Davenport software this will be your point of reference. Once...
You can't "Be too rich, too thin, or have too much spark". :p
Air leak somewhere?
Has anyone seen a 2009 IHRA rulebook yet, was A/FC or N/FC even printed in it? Happy Holidays john No rule book yet. They haven't found a...
Just wondering. What if IHRA did pull out an 11th hour save for AFC. Would I be able to buy a couple of screw blowers cheap? :D:D
I would think that EMI is being created anywhere that high voltage is flowing.
When asked why the speed had been fairly low on a run with a great E.T. Eddie Hill is reported to have said "I got there so quick I didn't have...
Try this strangeeng1@ameritech.com
Rule is now 96% injected.
