Separate names with a comma.
"It is a good procedure that immediately after you start the car that you apply 12 volts to the Blue Wire either by the clutch switch or the...
All MSD timing controls, six shooters, etc. should be installed with an 8830 capacitor, as shown in the directions. :)
All MSD controls use various combinations of their technology, the 8973 doesn't contain anything that is not being used in other "boxes".
Andy McCoy is a small shop but we are very happy with our car.
Pabst Blue Ribbon ?
8973 is the best !
ps... random trivia: why is it called wd-40? Water Dispersant formula #40
Not sure, a lot of helicopter traffic in this area.
Neal Parker was driver but no announcement yet at the track.
Just to make this fun, we use the 50w Valvoline and have been using the same oil for 3 years, with a little fresh added once in a while. BAE P/M.
Did you put in new cam bearings?
Stay on really good terms with all your competitors. Somebody is bound to have what you need. ;)
It would probably be worth the inconvenience to keep them seperate. Parallel runs are the worst for RFI.
Most guys run too much end gap and oil ring tension, but this will never get you in trouble. ;)
There are some trucks and parts on e-bay. The last ones were made a few blocks from my home in Richmond IN.
Buying Stroud for 20 years, no problems.
To compare air temp numbers we need to relate them to ambient. What we are looking for is the number of degrees increase in the blower.
Using a gel lube really helps all Roots, but wear and temperature are also affected by much fuel is going through the blower and where and how it...
Not sure if this helps, but the 8973 takes 4 degrees to process.
Reading plugs on a dyno is very difficult. Watch the EGTs, fuel flow and BSFC. A dyno will not give you a race tuneup. :cool:
