Separate names with a comma.
i agree totally. will has to decide if hes helping the crooks, or not. looks likes hes in on this one. i was fortunate to get my deal semi...
oil me down did you figure out the oiling problem?
what address hard to say where it is. lenco is in lemon grove in san diego, rob moore is in downtown san diego, and jeffco is in lakeside san...
couldnt see any post on this yet, but i saw bob metzler of great lakes dragway passed away. i made my first pass at a real dragstrip in 1983 at...
read the posts refer to my post above. yes, shawn runs jeffco trans in san diego and does make the input shafts for donovan.
heres some old info http://www.insidetopalcohol.com/showthread.php?8466-Arias-Fontana-MBE-Hemi-Questions&p=142573&highlight=#post142573
shafts talked to shawn today. he recently made about 45 input shafts for donovan recently. he should have them there for you.
align me had one break due to soft mag idler bracket being bent enough to put load on belt incorrectly. after puting new idler bracket on no...
Super side rails the new cn blocks also have billet side rails, and very sturdy ones also. i have a 10.2 cn block that the crank broke into many...
mbr the heads dont have a bbc bolt pattern. instead they have 10 of either 9/16 or 5/8 head studs with nascar lug nuts on top of the rocker...
mbr yes, 4.840 std chevy crank dimensions. however the cranks have chrystler rod bearings. most bocks are 10.7 height for fc, but they make 10.2...
wood http://anra.com/ heres some guys some friends of mine run with. its a lot more with the nostalgia than the rest. might be a place to start.
thread me again do a search on this subject, as there are many thoughts on this. in my humble opinion, the new miner, or old arias as it were, it...
Only one choice there is no debate. the chevy with the hemi heads wins hands down. period. next question!
check my strickstion check to see if somebody put a solid plug in the oil restriction hole, or if the restrictor in the middle bottom head stud...
easy calculator here http://engineersedge.com/manufacturing_spec/torque_wrench_1.htm
valve newby here, but ive seen a couple of k valves with the spool in upside down. im sure you know about the notch in the new ones, but the old...
input shaft you might call shawn at jeffco . he makes tons of input shafts for everybody....
rods in the side of the beam, where a lightening trough has been ground in the beam vertically, right in either the top or bottom of the trough...
my crack these are the new style forged venolia made to the b2 style. they had at least 60 runs in a 6 second altered. not a lot of revs. below 8500.
