Separate names with a comma.
129.6% correct! Brandon Booher NHRA TAD #34
We ran Jesel for about 6 yrs. and just this season switched to Morel. The reason behind our switch was cost, Jesel is $2800/set and Morel...
You're going to need more launch RPM to pull low gear the same, I'd recommend around 4500. You're coming from a 7.74 final drive ratio to a 7.00,...
CN Blocks will by far be the strongest BBC setup out there, hands down. www.cnblocks.com Brandon Booher NHRA TAD #34
We had the same issue with the standard tubes, we switched to Diversatech and problem solved. I have the Williams Covers this year, had Mike Laws...
VP-West Murrieta, CA Phone: 951-696-5100 Fax: 951-696-5577 vppacific@vpracingfuels.com Brandon Booher NHRA TAD #34
It also depends on dollar amount you're wanting to spend. If you're planning on trying to run quick, $5k is the range you'll be in for a two...
Coan Brandon Booher NHRA TAD #34
Depending on how much fuel your putting through it at WOT, you may or may no want a fuel bleed...if you have too much fuel in it, bye bye blower...
Did the pushrod jump the cup? More info would help.... Brandon Booher NHRA TAD #34
The 1.14 gear would be my concern, but above I see you said 1.41? 1.41 and 1.37 should be plenty aggressive with a 4:30. What are you exhaust...
The DMPE Flexplate doesn't use an adapter to the crankshaft. It moves the converter roughly .220" closer to the motor; getting that mass closer to...
Go Simpson, best helmets hands down. Brandon Booher NHRA TAD #34
You want to use a 2 stroke synthetic, or the lightest synthetic you can find. I spoke to PSI about the overfilling and the psynopsis is this; if...
Fill it to the bottom of the bottom snout bolt holes. As far as why it burns up gears, this is a pretty simple explanation....
From the mid plate to the mounting side (converter side) I'm .915" out. If you install a spacer on the flexplate you'll need to check pilot...
Are the sparks from the flexplate rubbing the midlpate or could it be the ring gear hitting the starter gear? We switched from the moly arp bolts...
Yes the dribblers are great for controlling idle temps, if the cylinder is cold then put a blank in that one. I saw you messaged me, I'll look...
Machine Design Services is the Rolls Royce of Leak Down Testers. www.machinedesignserviceinc.com/leakdowntester.html Brandon Booher NHRA...
What's the word? Looks like the inserts are here to stay via NHRA. Brandon Booher NHRA TAD #34
